API Audio Select T12 handleiding

18 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 6 van 18
T12 Tube Mic Preamp API Select
4
2.0 Quick Start
One tip to get started: We try to design all of our processing modules with the understanding that
there is never enough time to read a manual and learn all of the features in the 10 seconds that is
allowed during a setup. If you simply set all of the parameters as follows the T12 will have a useful,
but conservative effect on the signal.
After the unit has been powered on and warmed up*:
Connect a microphone to the INPUT XLR on the rear panel
Set MIC IMPEDANCE to 1500 OHMS
Set LOW CUT to OUT
Set GAIN to the fully counter-clockwise position
Set LEVEL to the fully clockwise position
Disengage the POL (polarity inverter) switch
Engage the 48V switch if a phantom-powered microphone is connected**
Engage the MIC switch to select the XLR microphone INPUT on the rear panel
Adjust the GAIN control to set the desired level
These settings will provide a good starting place for additional tweaking to achieve the desired sound.
*NOTE: The T12 is a tube-based processor that requires 15 minutes for the tubes to warm-up
to a stable temperature before tonal qualities become consistent.
**NOTE: CAUTION! Only engage the 48V switch when microphones that require 48-volt
phantom power are connected. Phantom power will damage many ribbon mics,
especially vintage ribbon mics, so use great care when engaging 48V phantom power.
**NOTE: CAUTION! Never connect or disconnect microphones when 48-volt phantom power
(48V) is engaged. Wait 5-10 seconds after the 48V switch is disengaged for the circuit
to discharge before disconnecting microphones.

Bekijk gratis de handleiding van API Audio Select T12, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkAPI Audio
ModelSelect T12
CategorieNiet gecategoriseerd
TaalNederlands
Grootte2518 MB