Anybus ProfiHub B2FO2+ handleiding
Handleiding
Je bekijkt pagina 12 van 41
ProfiHub B2FO2+ User Manual| February 2018 | © PROCENTEC 11/40
FO RX-OK
No communication
detected on this channel
☺ 1 or more devices
communicating on this
channel
Internal error
FO ERROR
☺ No problem has been
detected
Problem in the cabling
has been detected.
Problem in the cabling
has been detected
Channel RX-OK
There is no
communication detected
on this channel
☺ 1 or more devices
communicating on this
channel
Internal error
Channel ERROR
☺ No problem has been
detected
Problem in the cabling
has been detected
Problem in the cabling
has been detected
INT. TERM
Termination for this
channel is OFF
Internal error
Termination for this
channel is ON
1.12 The red Error LED
The red error LEDs will blink shortly if a corrupt message enters the ProfiHub. More specifically, this can be a
Parity error (the parity checksum of the byte is incorrect) or a Framing error (the FCS byte is different than the
real message). It is necessary to investigate further with an oscilloscope to find out what the problem is. This
can easily be done with ProfiTrace.
Another reason for the red error LED is a problem in the redundant cabling (if the ProfiHub is set to redundant).
If the redundant line is fixed, press the ‘Alarm Reset’ button.
It can also be that the baudrate is not locked (no PROFIBUS master on the bus) or the baudrate was set
manually and incorrectly with the rotary switch.
Bekijk gratis de handleiding van Anybus ProfiHub B2FO2+, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Anybus |
| Model | ProfiHub B2FO2+ |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11300 MB |
