Anchor Audio AN-30U2BT handleiding
Handleiding
Je bekijkt pagina 8 van 21
7
BASIC SYSTEM OPERATION
1. Plug the AC power cord into a wall power outlet or operate the unit using battery power.
If using battery power, ensure the batteries are fully charged.
2. Position the speaker to face your audience.
3. If you are using a wired microphone, plug the microphone into the ¼ MIC port.
4. To use an external audio device, plug one side of a 3.5mm cable into the device and the
other side of the cable into the LINE IN port.
5. To turn the AN-30 on, rotate the OFF knob clockwise. The Status light will turn red.
Note that this knob also controls the main volume of the speaker. Adjust as needed.
6. To pair or unpair your wireless microphones, see Wireless Microphone section.
You can use the Line In jack to play music or pre-recorded material through the AN-30. The
AN-30’s volume knob controls both the audio source and microphone levels. The volume can
also be controlled using the source audio’s volume controls.
1. Connect a 3.5 mm (mini plug) to the line or headphone output of your audio source.
2. Connect the other end of the 3.5 mm (mini plug) to the Line In port on the AN-30 back panel.
3. Adjust the volume of the external audio source as needed using the controls on the external
audio source or by adjusting the OFF knob on the AN-30, which controls the master volume.
CONNECTING AN EXTERNAL AUDIO DEVICE
Made in the USA
POWER
VOLUME
Master Control
INPUT
Wired Accessories connect
laptops, audio devices
INPUT
Wired
Microphones
MIC BOOST
Increases overall
microphone volume
WIRELESS RECEIVER
*If equipped
BLUETOOTH
Bekijk gratis de handleiding van Anchor Audio AN-30U2BT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Anchor Audio |
| Model | AN-30U2BT |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3101 MB |