Handleiding
Je bekijkt pagina 27 van 180
- 27 -
TROUBLESHOOTING
In the event of any fault:
• Turn o the appliance
• Disconnect the power supply
• Have the appliance repaired
• Based on the instructions given in the table below, some minor issues can be corrected
by the user. Please check the consecutive points in the table before you refer the repair
to customer service.
PROBLEM POSSIBLE CAUSE REMEDY
1.The appliance does
not work
- no power -Check the fuse, replace if blown
2.Sensor elds do
not respond when
touched
- Appliance is not turned on - Turn on the appliance
- Sensor eld touched too briey
(less than one second)
- Touch the sensor eld longer
- Multiple sensors touched at the
same time
- Always touch only one sensor eld
(except when a cooking zone is
switched o)
3.The appliance does
not respond and emits
and extended beep
- Improper use (wrong sensor elds
touched or sensors touched too
briey)
- Reconnect the hob
- Sensor elds covered or dirty - Uncover or clean the sensor elds
4.The appliance switch-
es itself o
- No sensor eld is touched for 10
seconds of activating the appliance
- Switch on the appliance and set heat
setting without delay
- Sensor elds covered or dirty - Uncover or clean the sensor elds
5.A single cooking zone
switches off and resid-
ual heat indicator „H” is
shown.
- Limited cook time - Switch on the cooking zone again
- Sensor elds covered or dirty
- Uncover or clean the sensor elds
- Electronic components overheated
6.Residual heat
indicator extinguished
even though the cook-
ing zones are hot
- A power outage or the appli-
ance has been disconnected
- Residual heat indicator will be
shown again the next time the ap-
pliance is turned on and o again
7.Hob cooking surface
is cracked.
Danger! Immediately unplug the appliance or switch o the main
circuit breaker. Refer the repair to the nearest service centre.
8.When the problem is
still not remedied.
Immediately unplug the appliance or switch o the main circuit breaker
(fuse). Refer the repair to the nearest service centre.
Important!
You are responsible for operating the appliance correctly and main-
taining its good condition. If you call service as a result of operating the
appliance incorrectly you will be responsible for the costs incurred even
under warranty.
The manufacturer shall not be held liable for damage caused by failure
to follow this manual.
9.Induction hob
makes buzzing sound.
This is normal. Cooling fan is operating to cool down internal electronics.
10. Induction hob
makes hissing and
whistling sounds.
This is normal. When using several cooking zones at full power, the
hob makes hissing and whistling sounds due to the frequencies used to
power the coils.
11. The hob does not
work. The cooking
zones will not operate.
- Faulty electronics
- Reset the appliance, unplug it
for a few minutes (disconnect the
fuse).
Bekijk gratis de handleiding van Amica KMI 751 000 E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Amica |
| Model | KMI 751 000 E |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 17424 MB |
