American DJ Gobo Projector IR handleiding

Niet gecategoriseerd

American DJ

6 pagina's

PDF beschikbaar

Handleiding

ADJ Products, LLC - www.adj.com - Gobo Projector IR User Manual Page 7

ADJ Products, LLC - www.adj.com - Gobo Projector IR User Manual Page 6

The Gobo Projector IR comes with 4 colored gels. These gels can

be used at anytime and allows you to add background color to your

gobo.

To add a color gel;

1. Unscrew and remove the lens housing.

2. Using a flat head screwdriver, gently and carefully remove the

retainer ring holding the lens into place.

3. Remove the lens and insert your desired gel. The gel should sit

pefectly on the small ledge inside the housing.

4. With the gel sitting perfectly, reinsert the lens. After the lens is

inserted, reinsert the retainer ring so that it sits snuggly against the

lens. There should be no play between the lens and retainer ring.

Gobo Projector IR Adding A Color Gel

Gobo Projector IR Photometric Chart

1.0 2.0 3.0 4.00

0m( )

5.0

(LUX)

10130 2400 1030 560 366

0.22 0.45 0.67 0.89 1.14

The Gobo Projector IR comes with a replaceable gobo. This gobo

can be interchanged at any time and allows you to customize your

system.

To replace gobo;

1. Unscrew the two screws located on the bottom of the unit that

hold the gobo housing.

2. Remove the gobo housing.

3. Once the gobo housing has been removed, remove the retaining

ring that holds the gobo in. This can easily be done using needle

nose pliers.

4. Remove and replace the gobo with your desired replacement

gobo. Reinsert the retainer ring, and make sure the ring rests

firmly against the gobo.

5. Slide the gobo assembly back into place, and secure the housing

with two screws.

Gobo Projector IR Gobo Replacement

Gobo Projector IR ADJ UC IR Control

The UC IR (sold separately) infrared remote gives you control of

various functions (See below). To control the fixture you must aim the

remote at the front of the fixture and be no more than 30 feet away.

STAND BY - Pressing this button will blackout the fixture.

FULL ON - This button is invalid for the fixture.

FADE/GOBO - Press this button to run or stop the effect.

“DIMMER +” and “DIMMER -” - Use these buttons to adjust the out-

put intensity.

STROBE - This button is invalid for the fixture.

COLOR - This button is invalid for the fixture.

1-9 - These buttons are invalid for this fixture.

SOUND ON & OFF - These buttons are invalid for this fixture.

SHOW 0 - This button is invalid for this fixture.

Bekijk gratis de handleiding van American DJ Gobo Projector IR, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.