American DJ Encore Burst RGBW IP handleiding

Verlichting

American DJ

26 pagina's

PDF beschikbaar

Handleiding

DMX ADDRESSING

All xtures should be given a DMX starting address when using a DMX controller, to ensure that

the correct xture responds to the correct control signal. This digital starting address is the channel

number from which the xture starts to “listen” to the digital control signal sent out from the DMX

controller. The starting DMX address is assigned by setting the correct DMX address on the digital

control display on the xture.

You can set the same starting address for all xtures or a group of xtures, or set dierent addresses

for each individual xture. Setting all xtures to the same DMX address will cause all xtures to react

in the same way; in other words, changing the settings of one channel will aect all the xtures si-

multaneously.

If you set each xture to a dierent DMX address, each unit will start to “listen” to the channel num-

ber you have set, based on the quantity of DMX channels of each xture. That means changing the

settings of one channel will only aect the selected xture.

In the case of the Encore Burst RGBW IP, when in 4 channel mode you should set the starting DMX

address of the rst unit to 1, the second unit to 5 (4 + 1), the third unit to 9 (5 + 4), and so on. (See

chart below for more details.)

Channel Mode Unit 1 Address Unit 2 Address Unit 3 Address Unit 4 Address

4 Ch

1 5 9 13

6 Ch

1 7 13 19

7 Ch

1 8 15 22

8 Ch

1 9 17 25

11 Ch

1 12 23 34

ADJ Products, LLC - www.adj.com - Encore Burst RGBW IP User Manual Page 12

Bekijk gratis de handleiding van American DJ Encore Burst RGBW IP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.