American DJ Encore Burst RGBW IP handleiding

Verlichting

American DJ

26 pagina's

PDF beschikbaar

Handleiding

DMX SET UP

DMX-512: DMX is short for Digital Multiplex. This is a universal protocol used as a form of commu-

nication between intelligent xtures and controllers. A DMX controller sends DMX data instructions

from the controller to the xture. DMX data is sent as serial data that travels from xture to xture

via the DATA “IN” and DATA “OUT” XLR terminals located on all DMX xtures (most controllers only

have a DATA “OUT” terminal).

DMX Linking: DMX is a language allowing all makes and models of dierent manufacturers to be

linked together and operate from a single controller, as long as all xtures and the controller are DMX

compliant. To ensure proper DMX data transmission, try to use the shortest path possible when link-

ing several DMX xtures. The order in which xtures are connected in a DMX line does not inuence

the DMX addressing. For example, a xture assigned a DMX address of 1 may be placed anywhere

in a DMX line: at the beginning, at the end, or anywhere in the middle. When a xture is assigned a

DMX address of 1, the DMX controller knows to send DATA assigned to address 1 to that unit, no

matter where it is located in the DMX chain.

Data Cable (DMX Cable) Requirements (For DMX Operation): The Encore Burst RGBW IP can

be controlled via DMX-512 protocol. The Encore Burst RGBW IP has multiple DMX channel modes.

Your unit and your DMX controller requires a 5-pin XLR connector for data input and data output. We

recommend Accu-Cable DMX cables. If you are making your own cables, be sure to use standard

110-120 Ohm shielded cable (This cable may be purchased at almost all pro lighting stores). Your

cables should be made with a male XLR connector on one end and a female XLR connector on the

other. Also remember that DMX cable must be daisy chained and cannot be split.

Special Note: Line Termination. When longer runs of cable are used, you may need to use a ter-

minator on the last unit to avoid erratic behavior. A terminator is a 110-120 ohm 1/4 watt resistor

which is connected between pins 2 and 3 of a male XLR connector (DATA + and DATA -). This unit is

inserted in the female XLR connector of the last unit in your daisy chain to terminate the line. Using a

cable terminator (ADJ part number Z-DMX/T) will decrease the chance of erratic behavior.

TO MAINTAIN IP65 RATING INTEGRITY AND PREVENT WATER FROM ENTERING THE FIX-

TURE, ALL UNUSED CONNECTION RUBBER CAPS MUST BE SEALED AND ONLY IP65 RATED

POWER AND DATA CABLES MAY BE USED.

ADJ Products, LLC - www.adj.com - Encore Burst RGBW IP User Manual Page 11

Bekijk gratis de handleiding van American DJ Encore Burst RGBW IP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.