American DJ Encore Burst 100 IP handleiding

Niet gecategoriseerd

American DJ

22 pagina's

PDF beschikbaar

Handleiding

ADJ Products, LLC - www.adj.com - Encore Burst 100 IP User Manual Page 14

Gamma - In this menu you are able to make gamma corrections.

1. Press either the MENU, UP, or DOWN buttons until “Gamma” is displayed and press ENTER.

2. Use the UP or DOWN buttons to adjust the gamma brightness.

3. Once you have found your desired setting press ENTER to conrm.

Tungsten - In this menu you can activate the Tungsten Filament effect.

1. Press either the MENU, UP, or DOWN buttons until “Tungsten” is displayed and press ENTER.

2. Use the UP or DOWN buttons to toggle between “ON” and “OFF”. “ON” will activate this eect

and “OFF” will deactivate it.

3. Once you have found your desired setting press ENTER to conrm.

Display - This submenu has two functions: (1). The display can be set to turn off after 20

seconds or set to stay on at all times. (2). You can set the control panel to lock after 30 seconds.

1. Press either the MENU, UP, or DOWN buttons until “Display” is displayed and press ENTER.

2. Use the UP or DOWN buttons to switch between “Backlight” and “Display Lock”. Press the

ENTER to select the setting you would like to adjust.

3. Use the UP or DOWN buttons to toggle between “ON” and “OFF” for each function.

- Backlight - “ON” will keep the display on at all times, and “OFF” will have the display turn o after

20 seconds. To “light” the display press 1 of the 4 buttons.

- Display Lock - “ON” will lock the display control after 30 seconds, and “OFF” will leave the display

control unlocked. To unlock the display press any 1 of the 4 buttons for at least 5 seconds.

4. Once you have found your desired settings press the ENTER button to conrm.

Service - With this function the unit can calibratated or reset to its default settings. The

password is “11” to access this submenu. NOTE: ONLY QUALIFIED TECHNICIANS SHOULD

PERFORM THE CALIBRATION FUNCTION.

1. Press either the MENU, UP, or DOWN buttons until “Service” is displayed and press ENTER.

2. “Pass Code” and “X” will now be displayed. “X” represents the current displayed number.

3. Use the UP and DOWN buttons to “set” the pass code and press ENTER.

4. To reset the unit to the factory settings, press the UP or DOWN buttons until “Factory Restore” is

displayed and press ENTER.

Encore Burst 100 IP Operating Instructions

Bekijk gratis de handleiding van American DJ Encore Burst 100 IP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.