American Audio Accu Spot Pro handleiding

Niet gecategoriseerd

American Audio

26 pagina's

PDF beschikbaar

Handleiding

American DJ® - www.americandj.com - Accu Spot Pro Instruction Manual Page 35 American DJ® - www.americandj.com - Accu Spot Pro Instruction Manual Page 36

Accu Spot Pro Error Codes

When power is applied, the unit will automatically enter a

“reset/test” mode. This mode brings all the internal motors to a

home position. If there is an internal problem with one or more

of the motors an error code will ash in the display in the form

of “XXer”, “XX” will represent a function number. For example,

when the display shows “02Er,” it means there is some type

of error with the channel 2 motor. If there are multiple errors

during the start-up process they will all ash in the display. For

example: if the xtures has errors on channel 1, channel 2, and

channel 3 all at the same time, you will see the error message

ash “01Er”, “02Er,” and ”03Er” repeated 5 times.

If an error does occur during the initial start-up procedure the

xture will self-generate a second reset signal and try to realign

all the motors and correct the errors, if the errors persist after a

second attempt a third attempt will be made.

If after a third attempt all the errors have not been corrected the

xture will make the following determinations:

1) 3 or more errors - The xture cannot function properly with

three or more errors therefore the xture will place itself in a

stand-by mode until subsequent repairs can be made.

2) Less than 3 errors - If the xture has less than 3 errors, there-

fore most other functions will work properly. The xture will

attempt to operate normally until the errors can be corrected by

a technician. The errors in question will remain ashing in the

display as a reminder of internal errors.

01Er – PAN movement error:

If the yoke is not located in the default position after start-up or

after a reset command. This message will appear after a xture

reset, if the pan-yoke’s magnetic-indexing circuit malfunctions

(sensor failed or magnet is missing) or there is a stepper motor

failure (defective motor or a defective motor IC drive on the

main PCB).

Accu Spot Pro Editing Program

Editing procedure 3: Record the selected scenes automati-

cally from external controller:

1. Access the main menu.

2. Select “EDIT” by pressing the UP or DOWN buttons, press

ENTER.

3. Press the UP button until the display shows “STEP”, press

ENTER.

4. Now adjust and set the number of steps by pressing the

UP or DOWN buttons. Press ENTER to conrm the number of

steps, and “PASS” will display briey.

5. Now press the DOWN button until “REC” is displayed, and

press ENTER.

6. The display will now show “RE.XX”, “XX” stands for the scene

number in the internal memory which the scenes from the con-

troller will be stored to. Press ENTER when you have chosen

the scene number.

7. Call up the scenes on the controller, and the xture will

record the scenes from the controller automatically. After the

number of scenes as selected in the “STEP” menu are loaded

into the xture, it will stop the procedure and return to the pre-

vious menu.

8. Press MODE/ESC to exit the “EDIT” menu and return to the

main menu.

Bekijk gratis de handleiding van American Audio Accu Spot Pro, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.