American Audio Accu Spot 250 handleiding

Niet gecategoriseerd

American Audio

20 pagina's

PDF beschikbaar

Handleiding

RTILT (Reverse Tilt) - Reverses the tilt.

LODA - Restores factory settings.

VER (Version) - Software version 2.2

ADJUST MENU -

LADJ (Lamp Adjustment) - With this function you can adjust

the lamp via the control board. In this mode, the device will not

react to any control signal.

TEST (Test) - Tests the functions of each channel. There are eight

channels, but only channels 1,2,3,4, and 6 can be tested.

TIME MENU -

CLLT - Clears the lamp running time.

NAT 1 - Displays the ﬁxture running time.

LAT 1 - Displays the lamp running time.

CLNT - Clears the ﬁxture running time.

EDIT MENU -

STEP (Step) - Steps to be used in Edit Programming. See ediit

program. See page 27.

SCO1 - SC48 (Scene 01 - Scene 48) - These are the scene slots

that you write your programs into. See edit program, page 28.

TIME (Time) - Time for each scene. See page 28.

CNIN - Edit program using a external controller. See page 30.

C-01 - C-30 (Channel 1 - Channel 30) - The channels of each

scene that can be edited. See page 28.

Accu Spot 250™ System Menu

On-Board System Menu.

The Accu Spot 250™ comes with an

easy to navigate system menu. This next section will detail the func-

tions of each command in the system menu.

Enter Button -

To access the main menu locate the ENTER button

(3) on the side of the unit. Press this button for 3 seconds to activate

the system menu. Tap the UP button (5) until you reach function you

wish to change. When you reach the function you wish to change tap

the ENTER button. When a function is selected the menu will begin to

ﬂash, use the UP button to change the function. Once your changes

are made tap the ENTER button again to lock the change in the system,

if the ENTER button is not selected within eight seconds the system

will automatically return to menu section. To exit without making any

changes tap the EXIT/DN button (4).

Accu Spot 250™ System Menu

American DJ® - www.americandj.com - Accu Spot 250™ Instruction Manual Page 16American DJ® - www.americandj.com - Accu Spot 250™ Instruction Manual Page 15

MODE MAIN MENU -

ADDR DMX Address Setting via control board -

1. Access the main menu.

2. Tap the UP button until “NODE” is displayed, press ENTER.

3. Tap the UP button until “ADDR” will now be displayed. Press

ENTER.

4. Now the display will show “VALU”, press ENTER. Now, “A001”

should be displayed. Adjust the DMX address by pressing the

UP or DOWN buttons.

5. Press ENTER to conﬁrm.

6. Press the EXIT/DN button to return to the main menu.

When the display is on “A001”, you can directly press the UP

or DN buttons to change the DMX start address.

SLAV Deﬁne the unit as a slave, in master/slave mode -

1. Access the main menu.

Bekijk gratis de handleiding van American Audio Accu Spot 250, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.