Amcrest AMDV5M32 handleiding
Handleiding
Je bekijkt pagina 35 van 93
35
To set a storage path, click on the Browse button and select a storage path or folder in which snapshots
or recordings will be downloaded.
To revert to default settings, click the Default button. To confirm settings, click the OK button.
PTZ
This screen is used to configure Pan/Tilt/Zoom (PTZ) functionality. For more information on the settings
listed in this menu, please refer to the information provided below.
Channel: In the Channel list, select the channel that you want to connect the PTZ camera to.
Type: Local: Connect through RS485 port or coaxial cable. Remote: Connect through network by adding
IP address of PTZ camera to the DVR.
Control Mode: In the Control Mode list, select Serial. For series product, please select the control signal
is sent to the PTZ through the coaxial cable. For the serial mode, the control signal is sent to the PTZ
through the RS485 port.
Protocol: In the Protocol list, select the protocol for the PTZ camera, for example, select 3.0.
Address: In the Address box, enter the address for PTZ camera. The default is 1.
Note: The entered address must be the same as the address configured on the PTZ camera. If not
configured properly, the PTZ camera will not function in the DVR.
Baud Rate: In the Baud rate list, select the baud rate for the PTZ camera. The default is 9600.
Data Bit: The default is 8.
Stop Bit: The default is 1.
Parity: The default is None.
Click the Copy to button to copy the interface setting. Press the Refresh button to refresh the interface.
To confirm settings, click the OK button.
Channel Type
The channel type menu allows the user to configure specific channel types in the system. These channel
types include both Analog and IP channels configurations.
This is optional however, please note, adding an IP camera to the DVR, will conflict with AI features. The
number of IP cameras added to the DVR will be dependent on how many channels your specific model
supports. The DVR will be provided with specific channels for IP cameras, typically towards the bottom of
the channel list and will not replace an active analog channel in the DVR. To connect an IP camera to your
DVR, please follow the steps provided below:
1. Click on the Camera option located in the Management section of the Main Menu.
2. Click on Channel Type and select the IP channels from the IP column of the list.
3. Click on Apply. A prompt will appear, click OK and allow the DVR to reset.
4. Navigate back to the Camera menu and click on Camera List.
5. Click on Device Search to search for the IP camera you want to add and click on the enable checkbox.
Bekijk gratis de handleiding van Amcrest AMDV5M32, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Amcrest |
| Model | AMDV5M32 |
| Categorie | Bewakingscamera |
| Taal | Nederlands |
| Grootte | 23088 MB |
