Alto-Shaam 700-RW handleiding
Handleiding
Je bekijkt pagina 9 van 19
MN-35890 (Rev. 3) 04/16 • Round Wells • 7
INSTALLATION
REMOTE CONTROL HOUSING MOUNTING INSTRUCTIONS
FLEXIBLE WATER-
TIGHT TETHER
Apply a food grade silicone
along the outside edge of
the round well support flange.
1
1. Cut a 5-5/16" x 4-1/2" x 11-1/16" (133mm x 114mm
x 281mm) opening in the location where the
control is to be positioned.
2. Thoroughly clean and dry the mounting surface
around the control cut-out opening on which the
décor face will be applied.
NOTICE: The control face will not properly
adhere to an unclean surface.
3. Remove the décor face from the unit by removing
the two nuts
1
from the back of the housing.
4. Making sure "TOP" etching is at the top, route
control housing through opening cut in step 1.
Secure the décor face housing to the control
housing using the nuts removed in step 3.
5. Remove the protective film from the mounting
tape on the inside flanges of the décor face and
apply the décor face to the mounting surface. Two
holes are provided in décor face for additional
mounting screws (not provided) if desired.
Bekijk gratis de handleiding van Alto-Shaam 700-RW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Alto-Shaam |
| Model | 700-RW |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3177 MB |
