Alto-Shaam 300-S handleiding
Handleiding
Je bekijkt pagina 22 van 56
22 MN-29423 • Rev 6 • 02/18 • S-Series Hot Food Holding Cabinets
Operation
Deluxe Control
1. Preheat the holding cabinet at 200°F (93°C) for 30
minutes before loading hot food.
a) Press the ON/OFF button
2
. The ON/OFF status
indicator
1
will illuminate.
To reduce preheat time, rotate the vents inside the
door to close them.
b) Press the up arrow button
5
or the down arrow
button
6
until the controller shows 200°F (93°C).
• Press and release the button to change the
holding temperature by one degree.
• Press and hold the button to change the
holding temperature by ten degrees.
The heat indicator
3
illuminates and preheat
starts.
2. Wait thirty (30) minutes.
3. Place hot food in the holding cabinet.
WARNING
Only food which has been heated to an internal
temperature of 140°F to 160°F (60°C to 71°C) should be
placed in the holding cabinet.
Select at least one food item in every pan and insert
a food thermometer into the center to check internal
temperature. Heat any food items which are below
the minimum temperature before placing them in the
holding cabinet.
5. Close the holding cabinet door securely.
6. Press the down arrow button
6
until the controller
shows 160°F (71°C).
• Press and release the button to change the holding
temperature by one degree.
• Press and hold the button to change the holding
temperature by ten degrees.
How to Display Set-Point and Actual Holding
Temperature
To display the actual compartment temperature, press the
up arrow button
5
. The actual compartment temperature
will display for a short time and then the controller will
return to the set-point holding temperature.
How to Change Controller from Fahrenheit toCelsius
NOTE: The factory default is Fahrenheit.
With the controller OFF, press and hold the up arrow
button
5
until the controller shows °C.
Press either arrow button to change from °C to °F.
NOTE: The last selected setting is retained by the control
board if there is a power failure.
How to Enable/Disable the Beeper
NOTE: The factory default is ON.
With the controller OFF, press and hold the down arrow
button
6
. The controller will display “OFF”.
Press either arrow button to turn the Beeper on.
How to Lock the Controller
The controller lock prohibits the set temperature from
being changed.
Press and hold the ON/OFF button
2
and the up arrow
button
5
simultaneously. The lock status indicator
5
will
illuminate.
To unlock the controller, press and hold the ON/OFF
button
2
and the down arrow button
6
simultaneously.
The lock status indicator
5
will go out.
1
2
3
4
5
6
Bekijk gratis de handleiding van Alto-Shaam 300-S, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Alto-Shaam |
| Model | 300-S |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8939 MB |
