Alto-Shaam 300-S handleiding
Handleiding
Je bekijkt pagina 21 van 56
MN-29423 • Rev 6 • 02/18 • S-Series Hot Food Holding Cabinets 21
Operation
1. Preheat the holding cabinet at 200°F (93°C) for 30
minutes before loading hot food.
a) Press the ON/OFF switch
1
to the ON (I) position.
To reduce preheat time, rotate the vents inside the
door to close them.
b) Press the up arrow button
5
or the down arrow
button
4
until the controller shows 200°F (93°C).
• Press and release the button to change the
holding temperature by one degree.
• Press and hold the button to change the holding
temperature by ten degrees.
The heat indicator
2
illuminates and
preheatstarts.
2. Wait thirty (30) minutes.
3. Place hot food in the holding cabinet.
WARNING
Only food which has been heated to an internal
temperature of 140°F to 160°F (60°C to 71°C) should be
placed in the holding cabinet.
Select at least one food item in every pan and insert
a food thermometer into the center to check internal
temperature. Heat any food items which are below
the minimum temperature before placing them in the
holding cabinet.
5. Close the holding cabinet door securely.
6. Press the down arrow button
4
until the controller
shows 160°F (71°C).
a) Press and release the button to change the holding
temperature by one degree.
b) Press and hold the button to change the holding
temperature by ten degrees.
How to Display Set-Point or Actual Holding Temperature
NOTE: The factory default is the set-point holding
temperature.
Press and hold the temperature display button
3
and the
up arrow button
5
simultaneously, for ve (5) seconds.
The controller shows “ACT” for Actual compartment
temperature, or “SET” for the Set-point holding
temperature, and then the selected temperature.
NOTE: Press the temperature display button
3
at any time
to temporarily display the alternate temperature.
How to Change Controller from Fahrenheit toCelsius
NOTE: The factory default is Fahrenheit.
Press and hold the temperature display button
3
and the
down arrow button
4
simultaneously, for ve (5) seconds.
The controller shows °C for Celsius or °F for Fahrenheit,
then the temperature at the selected setting.
NOTE: The last selected setting is retained by the control
board if there is a power failure.
SureTemp™ Heat Recovery
The patented SureTemp™ heat recovery system in this
appliance will immediately compensate for any loss of
heat when the door is opened. In order to maintain a
more consistent compartment temperature, the control
will automatically apply heat to the appliance’s interior
while the door is open and for a short time aer the door
is closed. If the door remains open for more than three
minutes, the control will sound three rapid beeps every ten
seconds until the door isclosed.
Simple Control
I
o
I
o
1
2
3 4
5
Bekijk gratis de handleiding van Alto-Shaam 300-S, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Alto-Shaam |
| Model | 300-S |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8939 MB |
