Alpine SPX-Z15M handleiding
Handleiding
Je bekijkt pagina 17 van 52
15
English
Type-1A (option): While the mounting con-
figuration is the same as Type-1A, this net-
work setting provides a variation for particu-
lar cases where either personal taste or ve-
hicle acoustics requires a more gradual
slope on the tweeter. In this case, the
tweeter high-pass is a very low Q 2
nd
Order,
with a roll-off starting at 6dB/oct. and end-
ing at 12dB/oct. To achieve phase linkage
between the two drivers, the tweeter phase
is inverted by reversing its physical connec-
tion within the network. Essentially, the par-
allel coil eliminates the influence of the reso-
nance frequency, and the tweeter rolls off
12dB/oct. below 1kHz. The woofer low-pass
is a semi-1
st
Order with a very gradual slope
of 3-4dB/oct. The resultant acoustic crosso-
ver point between the two drivers is 2.2kHz.
10
0
–10
–20
–30
–40
–50
2.0Hz 3.0Hz 100Hz 300Hz 1.0kHz 3.0kHz 10kHz 30kHz
HP-1
IN
OUT
IN
OUT
HP-2
HP-3
HP-4
HP-5
BYPASS
TW HP
LP-1
BYPASS
+
—
SIGNAL
LINK
SPX—Z15M
TW LEVEL
TW PHASE
+6dB/45°
+4dB/30°
+2dB/15°
0dB/0°
–2dB
–4dB
LP-2
WF LP
Network Jumper Setting
Notes:
• Highlighted tweeter level jumpers are the recommended settings for each configura-
tion, but some user adjustment may be desirable.
• Transfer function simulations only illustrate the effect of the filter upon the input sig-
nal, and therefore do not represent the actual frequency response of the system.
• If separate channels of amplification are used (bi-wire mode), the appropriate signal
link jumpers must be removed.
Bekijk gratis de handleiding van Alpine SPX-Z15M, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Alpine |
| Model | SPX-Z15M |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4420 MB |
