Alpine SPX-Z15M handleiding
Handleiding
Je bekijkt pagina 16 van 52
14
Type-1A: Pathlength to the listening posi-
tion is considered to be equal in this case,
with relative on-axis positioning of both driv-
ers. Phase linkage accomplished with a rela-
tively high Q 3
rd
Order high-pass filter on the
tweeter, resulting in a 12dB/oct. roll-off at the
starting point that steepens to 18dB/oct.
below 2kHz. The woofer low-pass is a semi-
1
st
Order with a very gradual slope of 3-4dB/
oct. As a result, the acoustic crossover point
between the two drivers is 2.8kHz.
System Type 1
10
0
–10
–20
–30
–40
–50
2.0Hz 3.0Hz 100Hz 300Hz 1.0kHz 3.0kHz 10kHz 30kHz
Network Jumper Setting
HP-1
IN
OUT
IN
OUT
HP-2
HP-3
HP-4
HP-5
BYPASS
TW HP
LP-1
BYPASS
+
—
SIGNAL
LINK
SPX—Z15M
+6dB/45°
+4dB/30°
+2dB/15°
0dB/0°
TW LEVEL
TW PHASE
–2dB
–4dB
LP-2
WF LP
Notes:
• Highlighted tweeter level jumpers are the recommended settings for each configura-
tion, but some user adjustment may be desirable.
• Transfer function simulations only illustrate the effect of the filter upon the input sig-
nal, and therefore do not represent the actual frequency response of the system.
• If separate channels of amplification are used (bi-wire mode), the appropriate signal
link jumpers must be removed.
Bekijk gratis de handleiding van Alpine SPX-Z15M, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Alpine |
| Model | SPX-Z15M |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4420 MB |
