Aiwa ZENKAISUI EVO 6 AVC-640 handleiding
Handleiding
Je bekijkt pagina 14 van 108
ENGLISH
• After installation, try pulling the battery pack down. If the battery pack does not
move, it means that it is properly assembled.
Note: If you are not going to use the vacuum cleaner for a long period, remove the
battery, pack the machine, and store it in a cool, dry place. Do not place in direct
sunlight or in a humid environment.
INSTALLING THE FLOOR BRUSH AND METAL TUBE ASSEMBLY ON THE
HANDHELD VACUUM CLEANER (IMAGE 4)
• First, follow the installation method of electric floor brush and metal pipe to
complete your installation.
Installing the Floor Brush and Metal Tube Assembly on the Handheld Vacuum:
• As shown in the figure, align the conductive needle of the metal tube with the
pumpkin-shaped conductive tube of the suction nozzle.
• Push it up until you hear a "click" sound indicating the lock.
CONNECTION OF ACCESSORIES (IMAGE 5)
For ease of use, this product comes specially equipped with some accessories for the
hand part of the vacuum cleaner.
When using the handheld vacuum alone:
• You can connect the accessories directly.
You can make the connection between the handheld vacuum cleaner, two-in-on
e
flat suction nozzle, electric mite removal brush, two-in-one suction nozzle for sofa as
shown in the figure.
USING THE VACUUM CLEANER
CHARGING THE BATTERY
Notes:
1. When using this product for the first time, the battery capacity of the vacuum
cleaner will not be fully charged. The machine needs to be placed on the
charging dock to charge it. Otherwise, the battery will be too low and you may
not be able to turn on the product at the high speed. It can be used normally
after being fully charged.
2. During the first three times the vacuum cleaner is used, it is recommended that
each charging time be up to 12 hours. After a full charge and discharge, the
vacuum cleaner can be charged and used according to the normal charging
method.
3. The charging time for this model is approximately 3.5 hours. After charging,
remove the power supply in time and disconnect the charging dock plug from
the AC outlet to stop charging.
4. If the power cord is damaged, to avoid hazards, it should be replaced by
professionals from the manufacturer, its maintenance department, or similar
departments.
CHARGING AND DISPLAYING THE VACUUM CLEANER DISPLAY
• When the vacuum cleaner display shows that the battery power is less than or
equal to 20%, the machine will automatically switch to the mode where the high
speed is not found. If the battery indicator always remains red, the user i
s
advised to recharge the vacuum cleaner.
• Charging method: The battery pack is placed in the charging dock along with
the charging machine to charge it, insert the adapter plug into the AC outlet and
connect the other end of the adapter to the charging dock to charge it. During
Bekijk gratis de handleiding van Aiwa ZENKAISUI EVO 6 AVC-640, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Aiwa |
| Model | ZENKAISUI EVO 6 AVC-640 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 11492 MB |
