Handleiding
Je bekijkt pagina 17 van 96
Problem Possible cause Solution
There is no voltage in the mains
socket.
Connect a different electrical appli‐
ance to the mains socket. Contact a
qualified electrician.
The appliance is noisy. The appliance is not supported
properly.
Check if the appliance stands sta‐
ble.
Acoustic or visual alarm is on. The cabinet has been recently
switched on.
Refer to "High temperature alarm"
or "Door open alarm".
The temperature in the appliance is
too high.
Refer to "High temperature alarm"
or "Door open alarm".
The door is left open. Close the door.
The compressor operates continual‐
ly.
Temperature is set incorrectly. Refer to "Control panel" chapter.
Too much food is put in at the same
time.
Wait a few hours and then check the
temperature again.
The room temperature is too high. Refer to "Installation" chapter.
Food placed in the appliance is too
warm.
Allow food to cool to room tempera‐
ture before storing.
The door is not closed correctly. Refer to "Closing the door" section.
The Extra Freeze function is switch‐
ed on.
Refer to "Extra Freeze function"
section.
The Extra Cool function is switched
on.
Refer to "Extra Cool function" sec‐
tion.
The compressor does not start im‐
mediately after pressing the "Extra
Freeze" or "Extra Cool", or after
changing the temperature.
The compressor starts after a period
of time.
This is normal, no error has occur‐
red.
Door is misaligned or interferes with
ventilation grill.
The appliance is not levelled. Refer to installation instructions.
Door does not open easily. You attempted to re-open the door
immediately after closing.
Wait a few seconds between closing
and re-opening of the door.
The lamp does not work. The lamp is in stand-by mode. Close and open the door.
The lamp is defective. Contact the Authorized Service
Centre.
There is too much frost and ice. The door is not closed correctly. Refer to "Closing the door" section.
The gasket is deformed or dirty. Refer to "Closing the door" section.
Food is not wrapped properly. Wrap the food properly.
Temperature is set incorrectly. Refer to "Control panel" chapter.
Appliance is fully loaded and is set
to the lowest temperature.
Set a higher temperature. Refer to
"Control panel" chapter.
ENGLISH 17
Bekijk gratis de handleiding van AEG PCB7000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | AEG |
| Model | PCB7000 |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 8903 MB |
