Advantech UNO-137 V2 handleiding
Handleiding
Je bekijkt pagina 5 van 19
UNO-137 V2 Startup Manual 5
Install mPCIe
1. Remove the pre-installed screw and insert mPCIe card.
Then put the screw back in place.
DIN-Rail Mount Installation
1. Install the UNO-137 V2 on the rail and secure it to the
rail.
2. Pull down the “Release Latch” for disassembly using a
screwdriver.
1. Read these safety instructions carefully.
2. Keep this startup manual for future reference.
3. Disconnect this equipment from any AC outlet before
cleaning. Use a damp cloth. Do not use liquid or spray
detergents for cleaning.
4. For plug-in equipment, the power outlet socket must
be located near the equipment and must be easily
accessible.
5. Keep this equipment away from humidity.
6. Put this equipment on a reliable surface during installa-
tion. Dropping it or letting it fall may cause damage.
7. The openings on the enclosure are for air convection.
Protect the equipment from overheating. DO NOT
COVER THE OPENINGS.
8. Make sure the voltage of the power source is correct
before connecting the equipment to the power outlet.
9. Position the power cord so that people cannot step on
it. Do not place anything over the power cord.
10. All cautions and warnings on the equipment should be
noted.
11. If the equipment is not used for a long time, disconnect
it from the power source to avoid damage by transient
overvoltage.
12. Never pour any liquid into an opening. This may cause
reorelectricalshock.
13. Never open the equipment. For safety reasons, the
equipmentshouldbeopenedonlybyqualiedservice
personnel.
14. If one of the following situations arises, get the equip-
ment checked by service personnel:
•The power cord or plug is damaged
•Liquid has penetrated into the equipment
•The equipment has been exposed to moisture
•The equipment does not work well, or you cannot get
it to work according to the user manual
•The equipment has been dropped or damaged
•The equipment has obvious signs of breakage
15. DO NOT LEAVE THIS EQUIPMENT IN AN ENVIRON-
MENT WHERE THE STORAGE TEMPERATURE
MAY GO BELOW -40°C (-40°F) OR ABOVE 85°C
(185°F). THIS COULD DAMAGE THE EQUIPMENT.
THE EQUIPMENT SHOULD BE IN A CONTROLLED
ENVIRONMENT.
16. CAUTION: DANGER OF EXPLOSION IF BATTERY IS
INCORRECTLY REPLACED. REPLACE ONLY WITH
THE SAME OR EQUIVALENT TYPE RECOMMENDED
BY THE MANUFACTURER, DISCARD USED BAT-
TERIES ACCORDING TO THE MANUFACTURER’S
INSTRUCTIONS.
17. The sound pressure level at the operator’s position
according to IEC 704-1:1982 should be no more than
70 dB (A).
18. RESTRICTED ACCESS AREA: The equipment should
only be installed in a restricted access area.
19. DISCLAIMER: This set of instructions is given accord-
ing to IEC 704-1. Advantech disclaims all responsibility
for the accuracy of any statements contained herein.
Simple Maintenance Process (Cont.)
Safety Instructions
Bekijk gratis de handleiding van Advantech UNO-137 V2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advantech |
| Model | UNO-137 V2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5593 MB |
