Advantech SQF-P10 P8 handleiding
Handleiding
Je bekijkt pagina 28 van 49
SQFlash
CompactFlash Card
Specifications subject to change without notice, contact your sales representatives for the most update information.
REV 1.7 Page 28 of 49 Feb. 3, 2014
This command is identical to the READ SECTORS command, except that DRQ is never set and no data
is transferred to the host.
15. RECALIBRATE (code: 1Xh);
This command return value is select address mode by the host request.
16. SECURITY DISABLE PASSWORD (code: F6h);
This command transfers 512Bytes of data from the host. Table Security Password defines the content of
this information.
17. SECURITY ERASE PREPARE (code: F3h);
This command shall be issued immediately before the SECURITY ERASE UNIT command to enable
device erasing and unlock. This command prevents accidental erase of the device.
18. SECURITY ERASE UNIT (code: F4h);
This command requests transfer of a single sector of data as form of table SECURITY ERASE UNIT
password from the host.
If the password is not match, this command will be reject, the Security Erase Prepare command should
be completed immediately prior the Security Erase Unit command.
If Normal Erase mode, the all user data area will be written binary 0, if Enhanced Erase mode, the
predetermined data pattern will written to the user data area.
19. SECURITY FREEZE LOCK (code: F5h);
This command sets the device to Frozen mode. After command completion, all other commands that
update device lock mode shall be command aborted. Frozen mode shall be disabled by power-off or
hardware reset.
20. SECURITY SET PASSWORD (code: F1h);
This command requests a transfer of a single sector of data from the host.
21. SECURITY UNLOCK (code: F2h);
This command requests transfer of a single sector of data from the host.
22. SEEK (code: 7Xh);
This command performs a range check.
23. SET FEATURE (code: EFh);
This command is used by the host to establish parameters that affect the execution of certain device
features.
24. SET MULTIPLE MODE (code: C6h);
This command enables the module to perform READ and Write Multiple operations and establishes the
block count for these commands.
25. SLEEP (code: 99h or E6h );
This command causes the module to set BSY, enter the Sleep mode, clear BSY and generate an
interrupt.
26. SMART ENABLE/DISABLE AUTO SAVE (code: B0h);
This command enables and disables the optional attribute auto save feature of the module.
27. SMART ENABLE OPEARIONS (code: B0h);
This command enables access to all SMART capabilities within the module.
Bekijk gratis de handleiding van Advantech SQF-P10 P8, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advantech |
| Model | SQF-P10 P8 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7715 MB |
Caratteristiche Prodotto
| Kleur van het product | Black, Blue, White |
| Breedte | 42.8 mm |
| Diepte | 36.4 mm |
| Hoogte | 3.3 mm |
| Intern geheugentype | SLC |
