Advantech PCL-833 handleiding
Handleiding
Je bekijkt pagina 16 van 28
PCL-833 User Manual 8
2.1 Hardware installation
Warning!
Disconnect power from PC when you install or remove the PCL-833 or its cable
1. Turn off the computer and all peripheral devices (such as printers and monitors).
2. Disconnect the power cord and any other cables from the back of the computer.
Turn the chassis so the back of the unit faces you.
3. Remove the chassis cover (see your computer users guide if necessary).
4. Locate the expansion slots at the rear of the unit and choose an unused slot.
5. Remove the screw that secures the expansion slot cover to the chassis. Save the
screw to secure the PCL-833.
6. Carefully grasp the upper edge of the PCL-833 card. Align the hole in the retain-
ing bracket with the hole on top of the expansion slot, and align the gold striped
edge connector with the expansion slot socket. Press the board firmly into the
socket.
7. Replace the screw in the expansion slot retaining bracket
8. Attach necessary accessories to the card
9. Replace the chassis cover. Connect the cables you removed in step2. Turn on
the computer.
Hardware installation is now complete. You can now install the software driver as
described in the next section.
2.2 Software Installation
We recommend you install the software driver before installing the PCL-833 card,
since this will guarantee a smooth installation process.
The DLL driver Setup program for the PCL-833 module is included on the companion
CD-ROM that is shipped with your module package.
For further information on driver-related issues, an online version of the Device Driv-
ers Manual is available by accessing the following path:
Start\Programs\Advantech Automation \Device Manager\Device Driver Manual
2.3 Switch & Jumper Settings
DIP switch SW1 sets the card's I/O address and jumper JPI sets the card's interrupt
level.
2.3.1 Base I/O Address (SW1)
The PCL-833 requires 16 consecutive I/O addresses. DIP switch SW1 (shown
below) sets the base I/O address.
Choose a base address that is not in use by any other I/O device. A conflict with
another device may cause one or both devices to fail. The factory address setting
(hex 200) is usually free as it is reserved for PC prototype boards.
Jumper settings for various base addresses appear below:
Bekijk gratis de handleiding van Advantech PCL-833, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advantech |
| Model | PCL-833 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1770 MB |
