Advantech PCE-5033 handleiding
Handleiding
Je bekijkt pagina 11 van 106
3 PCE-5133/5033 User Manual
Chapter 1 Hardware Configuration
1.3 Specifications
1.3.1 System
CPU: LGA1700-socket Core i9/i7/i5/i3, Pentium series processors.
L2 cache: Please refer to CPU specification for detailed information.
BIOS: AMI SPI BIOS (256 Mb SPI).
System chipset: Intel R680E (PCE-5133); Intel H610E (PCE-5033).
SATA hard disk drive interface: Six (PCE-5133) or four (PCE-5033) SATA3
(600MB/s) ports are with blue connector. These interfaces can be enabled/dis-
abled in the BIOS.
M.2 (2280) Type-M: Supports up to PCIe p11-x4 Gen 4 M-key 2280 type storage
devices.
1.3.2 Memory
RAM:
– PCE-5133: Up to 64 GB in two 288-pin DIMM sockets. Supports dual-chan-
nel DDR5 5600 (Depends on CPU) SDRAM with or without ECC function.
– PCE-5033: Up to 64 GB in two 288-pin DIMM sockets. Supports dual-chan-
nel DDR5 5600 (Depends on CPU) SDRAM without ECC function.
1.3.3 Input/Output
PCIe bus: One PCIex16 or two PCIex8 from CPU and one PCIe p11-x4 from PCH.
PCI bus: Four PCI masters to the backplane, 32-bit, 33 MHz PCI 2.2 compliant.
Serial ports: Two RS-232 serial ports.
USB port: Supports 6 x USB 2.0 ports with transfer rates up to 480 Mbps. (2
ports are on the CPU card and 4 ports are on the backplane), and PCE-5133
supports up to 6 USB 3.2 (Gen1) ports with transfer rates of up to 5 Gbps, 2
USB 3.2 (Gen2), and PCE-5033 supports 4x USB3.2 (Gen1).
SPI interface: Advantech-designed SPI connector supports optional TPM 2.0
module.
GPIO: Supports 8-bit GPIO from super I/O for general purpose control applica-
tion.
eSPI: eSPI pin header supports optional expansion of COM module .
Note! PCE-5133/5033 does NOT support PATA (IDE) interface.
Note! A 32-bit OS may not fully detect 4 GB of RAM when 4 GB is installed.
Please select Intel ECC supported processor to enable ECC function.
Note! Do not change the default settings unless an eSPI-interface COM mod-
ule is installed; otherwise, the system will not turn on. To use the COM
module, first power off the system and install the module. Then set
jumpers JESPI1 and JESPI2 to the 2-3 pin closed position. Power the
system back on and wait for the BIOS POST screen to appear. After-
ward, turn off the AC power, and finally, turn the system on again.
Bekijk gratis de handleiding van Advantech PCE-5033, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advantech |
| Model | PCE-5033 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 19454 MB |
