Advantech MIC-770 V2 handleiding
Handleiding
Je bekijkt pagina 25 van 110
11 MIC-770 V2 User Manual
Chapter 2 H/W Installation
2.2.2 Jumper List
2.2.2.1 Clear CMOS
The MIC-770 V2 single-board computer contains a jumper that can erase CMOS
data and reset the system BIOS information. Normally, this jumper should be set with
pins 1-2 closed. If you want to reset the CMOS data, set CMOS1 to 2-3 closed for
just a few seconds, then move the jumper back to 1-2 closed. This procedure will
reset the CMOS to its default setting.
2.2.2.2 System AT/ATX Mode Function Option
MIC-770 V2 supports AT or ATX mode and the default is the ATX module. If you want
to change to AT mode you can locate the AT/ATX mode jumper on the motherboard.
2.2.2.3 System ME Mode Function Option
MIC-770 V2 supports ME Enable & Disable and the default is “Disable”. If you want
to change the ME mode, you can set the ME mode jumper on the motherboard.
2.2.2.4 System Watchdog Mode Function Option
MIC-770 V2 single-board computer contains a jumper that can set watchdog mode.
Table 2.1: Jumper List
Label Function
JCMOS1 Clear CMOS
PSON1 System AT/ATX mode option
JME1 ME jumper mode option
JWDT1_JOBS1 Watchdog mode option
CMOS1 Clear CMOS
Footprint 3x1 Pin
Setting Function
(1-2) Normal (default)
(2-3) Clear CMOS
PSON1 System AT/ATX mode option
FootPrint 3x1 Pin
Setting Function
(1-2) AT module
(2-3) ATX module
JME1 System ME mode option
Footprint 3x1 Pin
Setting Function
(1-2) ME Enable (Default)
(2-3) ME Disable
JWDT1_JOBS1 Watchdog mode function option
Footprint 5x1 pin
Setting Function
(2-3) Watchdog
(4-5) ERR_BEEP
Bekijk gratis de handleiding van Advantech MIC-770 V2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advantech |
| Model | MIC-770 V2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7714 MB |
