Advantech IPC-603MB handleiding
Handleiding
Je bekijkt pagina 21 van 30
11 Chapter 2
2.4 Installing Add-in Cards
The IPC-603MB can accept up to three half-sized PCI add-in cards via
the riser card, which is inserted in the sixth slot of the enclosed ATX
motherboard and mounted on the L-form riser card bracket. To install an
add-in card, face to the rear side of the chassis and proceed as follows:
1. Find the riser-card slot(s) in which card(s) are to be inserted, then
remove the slot’s blank bracket(s) from the front plate of the chas-
sis.
2. Horizontally and evenly push the card leftwards until the gold fin-
gers are completely inserted into a PCI slot of the riser card. Make
sure that the card bracket has been inserted properly. Fasten the
card at the top of the bracket with a screw.
3. Repeat the previous step if there is more than one card.
2.5 Installing Rackmount Brackets & Handles
The IPC-603MB provides a pair of rackmount brackets and handles in the
accessory pack. To install the rackmount brackets and handles onto the
IPC-603MB, refer to Figure 2-6.
Figure 2-6 Install rackmount brackets and handles
handl e
handl e
rackmount bracket
rackmount bracket
Bekijk gratis de handleiding van Advantech IPC-603MB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advantech |
| Model | IPC-603MB |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1902 MB |
