Advantech BB-SR30819125-SWH handleiding
Handleiding
Je bekijkt pagina 26 van 61
SmartFlex SR308
5.9.2 Power connector PWR
Panel socket 2-pin.
Pin number Signal mark Description
1 GND(-) Negative pole of DC supply voltage
2 VCC(+) Positive pole of DC supply voltage (+10 to +60 V DC)
Table 7: Connection of power connector
Figure 21: Power connector
Unit has to be supplied by a power supply specified as a Limited Power Source (LPS) ac-
cording to Annex Q of IEC 62368-1. If the power supply/cable provided with device is not
used, always use the cables with minimum wire size (nominal cross section) 0.5 square mm
for power supply.
The power supply for the router must be between +10 V to +60 V DC supply. Protection
against reversed polarity without signaling is built into the router. Note: The protection against
reversed polarity is lost if the negative pole is grounded!
Circuit example:
Figure 22: Connection of power supply
Note for PoE: See Chapter 5.9.7 for information on how PoE versions of the router
impact the power supply usage. The power supply for a PoE router has to meet other
specific requirements.
All metal parts are connected together with the negative pole of power supply (common pole).
19
Bekijk gratis de handleiding van Advantech BB-SR30819125-SWH, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advantech |
| Model | BB-SR30819125-SWH |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8773 MB |
