Advantech ACP-4010 handleiding
Handleiding
Je bekijkt pagina 27 van 40
19 ACP-4010 User Manual
Chapter 3 Operation
3.5 Replacing the Power Supply
The ACP-4010 supports either a single PS/2 or a redundant power supply. To replace
the power supply, please proceed as below.
3.5.1 Replacing the Single PS/2 Power Supply
1. Unplug the power cord from the power supply.
2. Remove the top cover and the hold-down clamp.
3. Unplug the 20-pin (or 24-pin) ATX power connector and the 4-pin +12 V power
connector from the backplane/motherboard, as well as the power connectors
from all disk drives.
4. Loosen the six screws on the power supply bracket and then gently pull it up
(see Figure 3.7).
5. Replace the power supply with a new one and then fasten it onto the chassis.
6. Plug the 20-pin (or 24-pin) ATX power connector and the 4-pin +12 V power
connector to the backplane/motherboard, then plug other power connectors to
the disk drives and peripherals.
7. Return the hold-down clamp and top cover, then plug-in the power cord.
Figure 3.7 Replacing the single power supply
Bekijk gratis de handleiding van Advantech ACP-4010, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advantech |
| Model | ACP-4010 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3543 MB |
