Adler AD 7060 handleiding
Handleiding
Je bekijkt pagina 9 van 156
9
1. there is an exhaust filter cover on the back of the unit.
2 Turn it counterclockwise.
3. pull the cover to pull out the filter.
4. you can wash the filter with clean water.
5.If you wash the filter, remember to dry it thoroughly with a paper towel and then let it dry in a well-
ventilated dry room.
NOTE: NEVER USE THE DEVICE IF THE FILTERS ARE NOT FULLY DRY. REMEMBER TO USE
THE UNIT ONLY WITH FILTERS INSTALLED. OTHERWISE YOU WILL DAMAGE THE DEVICE.
6.After drying and cleaning the filters, install it again.
7. after some time, despite cleaning and maintenance of the air inlet filter and outlet filter, the performance of
the vacuum cleaner will decrease. This is caused by the wear and tear of the filters. In this case, contact your
dealer and replace the filters with new ones. Filter model: AD 7060.1.
Cleaning the LED SCANNER brush Illustration E page 5:
Remember to clean the electro brush regularly in order that it does not jam and serve for a long time for this
purpose:
1. turn off the device.
2. disconnect the brush from the device and the pipe.
3) Turn the brush with the bristles facing you.
4. on the left side you will find a latch that unlocks the brush shaft See illustration E1.
5. pull out the latch and then gently remove the roller. See illustration E2.
6) If there are tangled hairs on the roller, cut with scissors being careful not to damage the roller.
7. using a damp cloth and then a dry paper towel, clean the inside of the electro brush. Illustration E4.
8) Next, insert the roller, making sure that the roller wheel enters the bracket on the right side of the electro
brush.
Insert the latch into place.
Illustration E5.
Most common problems and solutions:
Problem Possible cause Possible solution
Vacuum cleaner does not collect dust
1. dust container is full
2. filter dirty or clogged
3. the filter has worn out
Empty the dust container 1.
2. clean the filters
3. replace filters
The roller does not spin
1. dust container is not closed
2. filters dirty or clogged
3. dust container not installed
correctly
4. low battery level
5. tube, cap, electro brush clogged
Close the dust container
Clean the filters
3 Install the dust container
correctly
4) Charge the batteries fully
5. unclog the cap, tube, electro
brush
t
Vacuum cleaner turns off by itself
The dust container is full
2. filter dirty or clogged
3. the vacuum cleaner overheats
Empty the dust container 1.
2) Clean the filters
3) Wait some time and try again
The vacuum cleaner does not turn on or does not
charge
1) The battery level is low
2. the vacuum cleaner is
overheated
Charge the battery to full 1.
2. wait some time and try again
Short operating time
1. low battery condition
2. filters dirty or clogged
1 Charge the battery fully
2. clean the filters
Bekijk gratis de handleiding van Adler AD 7060, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Adler |
| Model | AD 7060 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 16011 MB |
