Adj WiFLY Bar RGBA handleiding
Handleiding
Je bekijkt pagina 8 van 18
ADJ Products, LLC - www.adj.com - WiFly Bar RGBA User Manual Page 15
Master-Slave Configuration:
This function will allows you to link units together to run in a Master-Slave
mode. In Master-Slave operation one unit will act as the controlling unit
and the others will react to the controlling units built-in programs. Any
unit can act as a Master or as a Slave however, only one unit can be pro-
grammed to act as the “Master.”
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit.
Use standard XLR data cables to link your units together. Remember
that the Male XLR connector is the input and the Female XLR con-
nector is the ouput. The first unit in the chain (master) will use the
female XLR connector only. The last unit in the chain will use the
male XLR connector only.
2. Set the “Master” unit to your desired mode of operation.
3. On the “Slave” units press the MODE button
until “SLAu” is dis-
played. The unit is now set as the “Slave” unit. Each slave unit
must be set to the same setting.
4. Connect the rst “Slave” unit to the “Master”, and the “Slave” unit
should now start follow the “Master”.
WiFly Bar RGBA Master-Slave Configuration
ADJ Products, LLC - www.adj.com - WiFly Bar RGBA User Manual Page 14
WiFly Bar RGBA Operating Instructions
3. Press the UP or DOWN buttons to either activate the remote func-
tion (On) or deactivate it (Off).
WiFLY Address:
This function is used to set the WiFly address. This address must
match the address that is set to WiFly transceiver or WiFly controller.
1. Plug the fixture in and press the MODE button until “rcXX” is dis-
played. “XX” represents a number between 00-14.
2. Press the UP or DOWN buttons to select your desired address.
Remember, the address must be the same as WiFly transceiver or
WiFly controller.
Battery Life:
This menu is used to check/display the battery life.
1. Plug the fixture in and press the MODE button until “bXXX” is dis-
played. “XXX” represents a number between 0-100. The number
that is displayed is the remaining battery life. If “b---” is displayed,
it means either the battery is dead or your running the unit on AC
power.
With this feature you can connect the xtures to one another
using the IEC input and output sockets. The quantity that can be
connected is 20 xtures maximum. After 20 xtures you will need
to use a new power outlet. They must be the same xtures. DO
NOT mix xtures.
NOTE: Fixtures cannot be power cord daisy chained and run by
battery power.
WiFly Bar RGBA Power Cord Daisy Chain
Bekijk gratis de handleiding van Adj WiFLY Bar RGBA, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Adj |
| Model | WiFLY Bar RGBA |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2368 MB |
