Adj Vizi Q Wash7 handleiding
Handleiding
Je bekijkt pagina 10 van 41
ADJ Products, LLC — www.adj.com — Vizi Q Wash7 — Page 10
Power Supply: The ADJ Vizi Q Wash7 contains a electronic voltageswitch, which will
auto sense the voltage when it is plugged into thepower source. With the electronic
ballast you do not need to worryabout wall voltage, this unit can be plugged in anywhere.
DMX-512: DMX is short for Digital Multiplex. This is a universal protocol used by most
lighting and controller manufactures as a form of communication between intelligent
xtures and controllers. A DMX controller sends DMX data instructions from the controller
to the xture. DMX data is sent as serial data that travels from xture to xture via the
DATA “IN” and DATA “OUT” XLR terminals located on all DMX xtures (most controllers
only have a DATA “OUT” terminal).
DMX Linking: DMX is a language allowing all makes and models of different manufactures
to be linked together and operate from a single controller, as long as all xtures and
the controller are DMX compliant. To ensure proper DMX data transmission, when
using several DMX xtures try to use the shortest cable path possible. The order in
which xtures are connected in a DMX line does not inuence the DMX addressing. For
example; a xture assigned a DMX address of 1 may be placed anywhere in a DMX
line, at the beginning, at the end, or anywhere in the middle. When a xture is assigned
a DMX address of 1, the DMX controller knows to send DATA assigned to address 1 to
that unit, no matter where it is located in the DMX chain.
Data Cable (DMX Cable) Requirements: The Vizi Q Wash7 can be controlled via DMX-
512 protocol. The Vizi Q Wash7 is has 2 DMX channel modes, a 2 channel mode and 9
channel mode. The DMX address is set electronically
using the controls on the back panel of the unit. Your
unit and your DMX controllerrequire a approved
DMX-512 110 Ohm Data cable for data input and
data output. We recommend Accu-Cable DMX
cables. If you are making your own cables, be sure
to use standard 110-120 Ohm shielded cable (This
cable may be purchased at almost all professional
sound and lighting stores). Your cables should be
made with a male and female XLR connector on
either end of the cable. Also remember that DMX
cable must be daisy chained and cannot be split.
Vizi Q Wash7 DMX Setup
Bekijk gratis de handleiding van Adj Vizi Q Wash7, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Adj |
| Model | Vizi Q Wash7 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5770 MB |
