Adj Vizi Beam Hybrid 2R handleiding
Handleiding
Je bekijkt pagina 27 van 34
27
DMX SETUP
Power Supply: The ADJ Vizi Beam Hybrid 2R incorporates an electronic ballast, which automatically
Special Note: Line Termination: When using longer runs of cable, one may need to use a terminator on
the last unit to avoid erratic behavior. A terminator is a 110-120 ohm 1/4-watt resistor, which connects
between pins 2 and 3 of a male XLR connector (DATA + and DATA -). Insert this unit into the female XLR
connector of the last unit in one’s daisy chain to terminate the line. Using a cable terminator (ADJ part
number Z-DMX/T) will decrease the possibilities of erratic behavior.
5-Pin XLR DMX Connectors: Some manufacturers use 5-pin DMX-512 data cables for DATA transmission
instead of 3-pin. 5-pin DMX fixtures may be implemented in a 3-pin DMX line. When inserting standard
5-pin data cables into a 3-pin line, use a cable adaptor, readily available at most electric stores. The
chart below details a proper cable conversion.
A DMX512 terminator reduces signal errors,
avoiding most signal reection interference.
Connect PIN 2 (DMX-) and PIN 3 (DMX+) of
the last xture in series with a 120 Ohm, 1/4 W
Resistor to terminate the DMX512.
DMX +
COMMON
DMX512 IN 5-PIN XLR
DMX512 OUT 3-PIN XLR
DMX -
NOT USED
NOT USED
3-Pin XLR to 5-Pin XLR Conversion
Ground/Shield Pin 1 Pin 1
Data Compliment (- signal) Pin 2 Pin 2
Data True (+ signal) Pin 3 Pin 3
Not Used Do Not Use
Not Used Do Not Use
Bekijk gratis de handleiding van Adj Vizi Beam Hybrid 2R, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Adj |
| Model | Vizi Beam Hybrid 2R |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5180 MB |
