Adj Inno Spot LED WiFLY handleiding

Niet gecategoriseerd

Adj

14 pagina's

PDF beschikbaar

Handleiding

ADJ Products, LLC - www.adj.com - Inno Spot LED WiFly Instruction Manual Page 18 ADJ Products, LLC - www.adj.com - Inno Spot LED WiFly Instruction Manual Page 19

This feature will let you link units to run in a master-slave mode with-

out the use of XLR cables.

1. Follow the instructions on page 11 to set the Wireless address.

The addresses on each fixture must be the same.

2. After you have set the WiFly address, select your master unit and

set your desired operating mode.

3. Put the antenna in either a up position or down position then turn

the WiFly on. See page 11 to activate WiFly.

Note: All antennas must be in the same position, they must either be

all up or all down, but never at an angle.

4. For the Slave units, put the unit in Slave mode. See page 12.

Then activate WiFly.

5. If everything is set up correctly, the Master units signal strength

will be displayed in the WiFly signal status window located on the

rear of the unit.

NOTE: If they do not sync up master-slave, switch the Master fix-

tures power off then on again.

Inno Spot LED WiFly Operation

2. To control your fixture in DMX mode, follow the set-up procedures

on pages 5-7 as well as the set-up specifications that are includ-

ed with your DMX controller.

3. Use the controller’s faders to control the various DMX fixture traits.

4. This will allow you to create your own programs.

5. Follow the instruction on page 11 to set the DMX address.

6. For longer cable runs (more than a 100 feet) use a terminator on

the last fixture.

7. For help operating in DMX mode consult the manual included

with your DMX controller.

Sound Active Mode: This mode allows either single unit or several

units linked together, to run to the beat of the music.

1. Press the MENU button until “SOUN” is displayed, and press

ENTER. Tap the UP or DOWN buttons so that “ON” is dis-

played and press ENTER.

Show Mode: This mode allows either a single unit or several units

linked together, to run one of four shows that you choose. See pages

11-12 for more information.

1. Press the MENU button until “SHND” is displayed, and press

ENTER.

2. Press the UP or DOWN buttons until you nd your desired show,

and press ENTER.

Inno Spot LED WiFly UC3 Control

The optional UC3 Controller (not included) may be used to con-

trol different functions including blackout.

Stand By Blackout the unit

Function 1. Sync. Strobe

2. Async strobe

3. Sound Strobe

Show

1-4

1. Select Color

2. Select Gobo

Mode Sound (LED OFF) Show (LED

Slow Blinking)

LED ON

Inno Spot LED WiFly WiFly Master-Slave Set Up

Bekijk gratis de handleiding van Adj Inno Spot LED WiFLY, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.