Adj Illusion Dotz 3.3 handleiding

Niet gecategoriseerd

Adj

24 pagina's

PDF beschikbaar

Handleiding

ADJ Products, LLC - www.adj.com - Illusion Dotz 3.3 Instruction Manual Page 27ADJ Products, LLC - www.adj.com - Illusion Dotz 3.3 Instruction Manual Page 26

Illusion Dotz 3.3 System Menu

4. “XXXX” will now be displayed. “XXXX” represents the current run-

ning time.

5. Press ENTER or press MODE to exit.

TOTAL RUNNING TIME - This will allow you to check the units total

running time.

1. Press the MODE button to access the main menu. Press the UP

or DOWN buttons so that “Information” is highlighted, then press

ENTER.

2. Press the UP or DOWN buttons until “Time Information” is dis-

played, press ENTER.

3. Press UP or DOWN buttons, until “Total Time” is displayed, and

press ENTER.

4. “XXXX” will now be displayed. “XXXX” represents the total run-

ning time.

5. Press ENTER or press MODE to exit.

LAST CLEAR - This will allow you to check when the last running

time was cleared.

1. Press the MODE button to access the main menu. Press the UP

or DOWN buttons so that “Information” is highlighted, then press

ENTER.

2. Press the UP or DOWN buttons until “Time Information” is dis-

played, press ENTER.

3. Press UP or DOWN buttons, until “Last Clear” is displayed, and

press ENTER.

4. “XXXX” will now be displayed. “XXXX” represents the last running

time.

5. Press ENTER or press MODE to exit.

RUN PASSWORD - This will display the timer password.

1. Press the MODE button to access the main menu. Press the UP

or DOWN buttons so that “Information” is highlighted, then press

ENTER.

Illusion Dotz 3.3 System Menu

2. Press the UP or DOWN buttons until “Time Information” is dis-

played, press ENTER.

3. Press UP or DOWN buttons, until “Timer Pin” is displayed, and

press ENTER.

4. The “Timer Pin” is 050.

5. Press ENTER or press MODE to exit.

CLEAR LAST - This will allow you to clear the last run time of the

unit. You need to put in the Timer PIN before doing this. Please see

the section before this.

1. Press the MODE button to access the main menu. Press the UP

or DOWN buttons so that “Information” is highlighted, then press

ENTER.

2. Press the UP or DOWN buttons until “Time Information” is dis-

played, press ENTER.

3. Press UP or DOWN buttons, until “Clear Last” is displayed, and

press ENTER.

4. Either “O” or “On” will be displayed, use the UP and DOWN but-

tons to toggle between.

5. Press ENTER to conrm your selection or press MODE to exit.

TEMPERATURE INFO - This will allow you to check the moving

head temperature.

1. Press the MODE button to access the main menu. Press the UP

or DOWN buttons so that “Information” is highlighted, then press

ENTER.

2. Press the UP or DOWN buttons until “Temp. Info” is displayed,

press ENTER.

3. “Head Tem.” will now be displayed, press ENTER.

4. “XXX” will now be displayed. “XXX” represents the current tem-

perature of the moving head.

5. Press ENTER or press MODE to exit.

Bekijk gratis de handleiding van Adj Illusion Dotz 3.3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.