Adj Event Bar Pro handleiding
Handleiding
Je bekijkt pagina 11 van 26
11
SYSTEM MENU
Sound State - In this mode the unit will run in sound active mode.
1. Press the MENU button until “Sound State” is displayed, then press ENTER.
2. Either “On” or “O” will now be displayed, depending on the current setting. Use the UP or
DOWN buttons to toggle between “On” and “O”.
3. Press ENTER to conrm your selection, then press and hold the MENU button to activate.
Sound Sense - In this mode you can adjust the sound sensitivity of the sound active mode.
1. Press the MENU button until “Sound Sense” is displayed, then press ENTER.
2. Press the UP or DOWN buttons to adjust the sensitivity level. The sensitivity level can be adjust-
ed between 0 (least sensitive) and 100 (most sensitive).
3. Press ENTER to set your desired sensitivity level.
DMX State - This setting determines how the xture will behave when it powers up or when
the DMX signal is lost or interrupted.
1. Press the MENU button until “DMX State” is displayed, then press ENTER.
2. Either “Pri Sec”, “Blackout”, or “Last State” will be displayed. Choose an operating mode you
would like the unit to start up in when power is applied or the DMX signal is lost.
• Primary/Secondary - The unit will automatically go into Primary/Secondary mode.
• Blackout - The unit will automatically go into stand by mode.
• Last State - The unit will automatically go into the last DMX set up.
3. Press ENTER to conrm your desired set up.
Back Light - With this function you can make the backlight automatically turn o after one
minute.
1. Press the MENU button until “Back Light” is displayed, then press ENTER.
2. Either “ON” or “OFF” will now be displayed. Press the UP or DOWN buttons to select “ON” to
keep the backlight on at all times, or “OFF” to allow the backlight to turn o after 2 minutes.
Press any button to turn the backlight on again.
3. Press ENTER to conrm.
Auto Test - This function will run a self test program.
1. Press the MENU button until “Auto Test” is displayed, then press ENTER.
2. The xture will now run a self test. Press the MENU button to exit.
Pan Invert - Pan Inversion.
1. Press the MENU button until “Pan Invert” is displayed, then press ENTER. Either “Normal” or
“Inverse” will be displayed.
2. To activate the Pan inversion press the UP or DOWN buttons until “Inverse” is displayed, and
press ENTER to conm. To deactivate Pan inversion, select “Normal” and press Enter.
Tilt Invert - Tilt Inversion.
1. Press the MENU button until “Tilt Invert” is displayed, then press ENTER. Either “Normal” or “In-
verse” will be displayed.
2. To activate the Tilt inversion press the UP or DOWN buttons until “Inverse” is displayed, then
press ENTER to conm. To deacti-ate Tilt inversion, select “Normal” and press Enter.
Bekijk gratis de handleiding van Adj Event Bar Pro, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Adj |
| Model | Event Bar Pro |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2677 MB |
