Adj Event Bar Pro handleiding
Handleiding
Je bekijkt pagina 10 van 26
10
DMX Address - Set the DMX Address.
1. Press the MENU button until “DMX Addresss” is displayed, then press ENTER.
2. The currently selected address will now be displayed. Press the UP or DOWN buttons to scroll to
your desired address.
3. Press ENTER to conrm, and then press and hold the MENU button for at least three seconds to
assign.
Channel Mode - This will let you select your desired DMX Channel mode.
1. Press the MENU button until “Channel Mode” is displayed, then press ENTER.
2. The currently selected DMX Channel Mode will be displayed. Press the UP or DOWN buttons to
scroll to your desired Channel mode.
3. Press ENTER to conrm.
Pri/Sec Mode - This will let you set your unit as a primary or a secondary in a primary/second-
ary conguration.
1. Press the MENU button until “Pri/Sec Mode” is displayed, then press ENTER. Either “Pri”, “Sec
1”, or “Sec 2” will be displayed.
2. Press the UP or DOWN buttons until your desired setting is displayed, and press ENTER to con-
m.
NOTE: If one xture is set to “Pri”, and the next xture is set to “Sec 2”, the xtures will now have
contrasting movement with respect to each other.
Show Mode - Show modes 0-8 (Factory programs). Show mode can run with or without sound
active mode.
1. Press the MENU button until “Show Mode” is displayed, then press ENTER.
2. The currently selected show number will be displayed. Programs 1-8 are factory programs, while
“Show 0” is random mode. Press the UP or DOWN buttons to nd your desired show.
Dimmer Curve - In this mode you can select the dimmer curve. See the Dimmer Curve Chart
section of this manual for the dierent dimmer curve modes.
1. Press the MENU button until “Dimmer Curve” is displayed, then press ENTER.
2. The current dimmer mode will be displayed.
3. Press the UP or DOWN buttons to nd your desired dimmer mode and press ENTER to conrm.
Install Mode - This mode allows you to control the beam spread of the xture.
1. Press the MENU button until “Install Mode” is displayed, then press ENTER.
2. Either “INS 1”, “INS 2” or “INS 3” will be displayed.
• INS 1 - Long range beam (ceiling hanging)
• INS 2 - Short range beam (ceiling hanging)
• INS 3 - Front range beam (for truss or wall mounting)
3. Press the UP or DOWN buttons until your desired installation setting is displayed, and press EN-
TER to conm.
SYSTEM MENU
Bekijk gratis de handleiding van Adj Event Bar Pro, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Adj |
| Model | Event Bar Pro |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2677 MB |
