Adj Aria X2 IPC Bridge handleiding
Handleiding
Je bekijkt pagina 9 van 23
9
A DMX512 terminator reduces signal errors,
avoiding most signal reection interference.
Connect PIN 2 (DMX-) and PIN 3 (DMX+) of
the last xture in series with a 120 Ohm, 1/4 W
Resistor to terminate the DMX512.
DMX SETUP
DMX-512:
Digital Multiplex, or DMX, serves as a universal protocol utilized by most lighting and controller manufacturers
for communication between intelligent xtures and controllers. A DMX controller sends DMX data instructions
from the controller to the xture. DMX data is transmitted as serial data, traveling from xture to xture
through the DATA ‘IN’ and DATA ‘OUT’ XLR terminals found on all DMX xtures. Most controllers only have
a DATA ‘OUT’ terminal.
DMX LINKING:
As a language, DMX enables all makes and models from different manufacturers to be connected and
operated from a single controller, provided that all xtures and the controller are DMX compliant. To ensure
proper DMX data transmission when using multiple DMX xtures, use the shortest cable path possible. The
order in which xtures are connected in a DMX line does not affect the DMX addressing. For example, a
xture assigned a DMX address of 1 can be placed anywhere in a DMX line—at the beginning, at the end,
or anywhere in the middle. Therefore, the rst xture controlled by the controller could be the last xture in
the chain. When a xture is assigned a DMX address of 1, the DMX controller knows to send data assigned
to address 1 to that unit, regardless of its position in the DMX chain.
DATA CABLE (DMX CABLE) REQUIREMENTS:
The Aria X2 IPC Bridge can be controlled via the DMX-512 protocol. The
DMX address is electronically set using the controls on the front panel of
the unit. Both the unit and the DMX controller require an approved DMX-
512 110 Ohm Data cable for data input and output. Accu-Cable DMX
cables are recommended. If you are making your own cables, ensure that
you use standard 110-120 Ohm shielded cable (which can be purchased at
most professional sound and lighting stores). Cables should be made with
a male and female XLR connector on either end of the cable. Additionally,
keep in mind that DMX cable must be daisy-chained and cannot be split.
LINE TERMINATION:
When using longer runs of cable, one may need to use a terminator on the last unit to avoid erratic behavior. A
terminator is a 110-120 ohm 1/4-watt resistor, which connects between pins 2 and 3 of a male XLR connector
(DATA + and DATA -). Insert this unit into the female XLR connector of the last unit in your daisy chain to
terminate the line. Using a cable terminator (ADJ part number Z-DMX/T) will decrease the possibilities of
erratic behavior.
Bekijk gratis de handleiding van Adj Aria X2 IPC Bridge, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Adj |
| Model | Aria X2 IPC Bridge |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3059 MB |
