Adder View Matrix C110 handleiding
Handleiding
Je bekijkt pagina 41 van 84
40
INSTALLATIONCONFIGURATIONOPERATION
FURTHER
INFORMATION
INDEX
Port Settings
This page provides numerous network details for each of the installed
ports on the CAM.
Socket - Details the operational network socket.
MAC Address - Displays the unique, xed hardware identication
number for each port.
Link Up - Indicates whether the link state of this network interface is
up. This should be the case if the device is connected to a functioning
network.
IP Address - This shows the IP address in use, which can be obtained
via DHCP, a static IP or a link local (zero-cong).
Netmask - The netmask of this network interface. The device can
function in a network zero-cong state which does not require the
setting of a static netmask.
Gateway - The gateway address of this network interface. The device
can function in a network zero-cong state which does not require the
setting of a static gateway.
Static IP Address - When the ‘DHCP enabled’ option (below) is
unchecked, click on ‘Edit’ to enter/edit a static IP Address, Netmask and
Gateway for the unit.
DHCP Enabled - When ticked, the corresponding port will derive its IP
Address, Netmask and Gateway details from the DHCP server listed in
the eld below.
DHCP Server Address - Indicates the server that provided the DHCP
details.
CAM - Network
Bandwidth Limit - This option can be used to set an upper limit
(between 10 and 1000 Mbps aka 1Gbps) to the amount of the network
bandwidth used on the physical interface. This could be useful if multiple
devices share a common network link upstream; without a limit, the link
could become overloaded and drop data.
Routing Table - Click on ‘Details’ to show the routing table entries
corresponding to this network interface. In it are the destination address,
gateway and netmask for the routes to particular network destinations:
Network Settings
Default Domain - Reserved for future use.
Route of Last Resort - In a multi-interface device such as this, the
interface which is ticked will be used as the default whenever it is
unclear which interface should be used for network trafc.
Dynamic DNS Servers - List of DNS server addresses obtained via
DHCP.
Static DNS Servers - Lists DNS server addresses that have been
manually congured.
NTP Enabled - When ticked, the unit will derive its time and date
information from a suitable NTP server.
NTP Key ID - The ID of the key used for secure NTP.
NTP Key Value - The value of the key used for secure NTP as a
hexadecimal string.
Dynamic NTP Servers - Lists NTP server addresses obtained via
DHCP.
Static NTP Servers - Lists NTP server addresses that have been
manually congured.
To get here
You can access this page in two ways:
1 On the console keyboard attached to the USR, access the OSD by
pressing CTRL + ALT + C or tap the touchscreen icon. The
Preset Selection page will be displayed.
2 Click the icon in the top right corner.
3 Click the CAMs option and then click the icon for the
required CAM.
4 If necessary, click the Network link.
OR
1 Connect a computer to the same network as the CAM.
2 Run a web browser and enter the IP address of the CAM:
https://169.254.1.33 (this is the default address).
3 Click the icon in the top right corner.
4 If necessary, click the Network link.
Bekijk gratis de handleiding van Adder View Matrix C110, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Adder |
| Model | View Matrix C110 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 16799 MB |
