Zoom 506 handleiding
Handleiding
Je bekijkt pagina 3 van 6
• PATCH
A combination of several effects, each with individual parameter settings is called a "patch". The
506 comes with 24 preset patches which can be changed (edited) by the user.
• BANK
The 506 calls up patches in sets of four, called a "bank".
The 506 has memory capacity for 24 patches. At the factory, these are programmed with
recommended settings. The user can freely change the contents of any patch, and it is also
possible to restore the factory settings.
What Are Banks and Patches? PATCH LIST
Effect Connections
Controls and Functions
As shown in the illustration below, the 506 can be thought to contain seven "effect modules" which are
internally connected. In most effect modules, only one effect may be active at any given time, but the MOD
module can use two effects simultaneously. Therefore the 506 can act like a total of eight single effect devices.
INPUT
OUTPUT
Delay/Reverb
DLY/REV
Modulation
MOD
Equalizer
EQ
Amp Simulator
AMP
ZOOM Noise Reduction
ZNR
Distortion
DIST
Compressor
COMP
ZNR/AMP BLOCK
Compressor:
Keeps the input within a given
level range.
Limiter:
Restricts the input level.
Fat Wah:
Wah with wide emphasis
frequency range and a solid, fat
sound. Can be used as pedal wah
or auto wah.
Resonant Wah:
Strongly emphasizes a narrow
range while varying the
emphasized frequency. Can be
used as pedal wah or auto wah.
Clean1:
Clean sound with flat response.
Clean2:
Clean sound with lean midrange.
Fat:
Fat sound with prominent
midrange.
Slap:
Clean sound, ideal for slap type
playing.
Drive:
Drive sound with prominent
midrange that maintains a
distinct character also in
ensemble playing.
Vintage:
Husky vintage sound.
Fuzz:
Strongly distorted fuzz sound.
Thrash:
Thrashing metal type sound.
ZNR:
Noise reduction with natural
sounding cutoff.
AMP:
Makes the output sound as if
coming from a bass guitar
amplifier.
4band EQ:
Allows boost and cut in four
ranges: presence, high,
midrange, and low.
Phase Shift:
Applies a phase-shifted
component to the direct sound.
The amount of shift varies
periodically, resulting in a
breathing effect.
Chorus1:
Simple chorus with clean sound.
Chorus2 (Crystal Chorus):
Distinct ensemble chorus with
depth and ambience.
Flanger:
Adds a very short delay to the
direct sound and varies the delay
time periodically, resulting in a
peculiar sound character.
Synth:
Bass synthesizer sound that is
controlled by the bass input
signal.
Octaver:
Adds a one-octave lower sound to
the direct sound, making the
sound more full-bodied. Can also
be used as Octave+Chorus+Pedal
Pitch Shifter.
Delay:
Conventional digital delay with a
delay time of up to 370ms.
Hall Reverb:
Simulates the acoustics of a hall.
Room Reverb:
Simulates the acoustics of a
room.
STORE
EDIT
TUNER CAL .
EDIT VAL .
BANK
+
–
OUTPUT INPUT
COMP
DIST
GAIN
ZNR
AMP
EQ
MOD
LEVEL
/REV
DLY
1-30
COMP
FATWAH
CLN1
FAT SLAP
DRIVE VINTAGE
THRASH
FUZZ
CLN2
RESO WAH
LIMIT
1-30
1-9
EQ(1-50)
CHO1
SYNTH
CHO2 FLANGE
PHASE
A1-A9
UPDOWN
＃
♭
BYPASS
DELAY HALL ROOM
OCTAVE
BANK HOLD
ZOOM CORPORATION
MADE IN JAPAN
INPUT DC 9V CONTROL IN OUTPUT
300mA
[PHONES]
Top Panel
Rear Panel
OUTPUT jack
The output signal of the 506 appears at this jack.
You can connect either a single bass guitar amplifier, using a monaural
shielded cable, or two bass guitar amplifiers, using a Y-type stereo
shielded cable, or a pair of stereo headphones. If the volume level is low
when using headphones, increase the patch level or master level, or use
headphones with low impedance (32 ohms or less).
CONTROL IN jack
When the optional expression pedal FP01 is connected to this jack, it
can serve as volume pedal or be used for pedal wah and pedal pitch.
When the optional foot switch FS01 is connected, it can serve for bank
UP switching.
TUNER indicator
In the Bypass (Mute)/Tuner mode, this indicator shows that the tuner is
active, and it serves as a gauge for fine tuning your instrument.
• Battery empty warning
When the unit is powered from the battery, this indicator begins to flash
when the battery is exhausted.
STORE key
Serves to initiate and execute the store function for patches.
• Direct Load function
When the key is held down for at least 1 second in the Play mode, the
Direct Load function is turned on or off.
EDIT key
This key serves to toggle between the Play mode (where effects are
used for playing the instrument) and Edit mode (where the user can
freely change patch settings). The Edit mode is also used to select effect
parameters.
When the key is pressed while a Delay/Reverb effect parameter is
selected, the unit switches back to Play mode.
• Bank Hold function
When the key is held down for at least 1 second in Play mode, the Bank
Hold function is turned on or off.
INPUT jack
Serves for connection of the bass guitar.
The output level of bass guitars fluctuates considerably, depending on
the type of instrument and the playing technique. Use the compressor
and limiter of the COMP module to control the input level, or adjust the
output level control of the bass guitar to prevent overload.
When the unit is powered from the battery, the INPUT jack also
functions as on/off switch. Plugging a shielded cable into the jack turns
the 506 on. When not using the unit, the cable should be disconnected to
prevent battery drain.
DC IN jack
Serves for connection of an AC adapter (Zoom AD-0006) which
delivers 9 V DC, 300 mA with a "center minus" plug configuration.
When the AC adapter is connected to this jack, the 506 is turned on.
Display
Shows information required to operate the 506.
• Play mode:
Shows the currently selected bank and patch.
• Edit mode:
Shows the value of the parameter currently being edited.
• Bypass (Mute)/Tuner mode:
Shows the pitch of the input signal.
Parameter cursor LEDs
• Play mode:
The currently used effect module lights up.
• Edit mode:
The currently used effect module lights up. When selected for editing,
the indicator for the effect module flashes.
• Bypass (Mute)/Tuner mode:
Indicators function as tuning meter.
VALUE + / - keys
• Play mode:
The keys serve for bank switching.
• Edit mode:
The keys serve for changing the effect parameter.
• Bypass (Mute)/Tuner mode:
The keys serve for setting the tuner reference pitch (calibration).
Patch UP / DOWN pedals
• Play mode:
The pedals serve for patch switching. Pressing both pedals
simultaneously activates the Bypass (Mute)/Tuner mode.
• Edit mode:
The pedals serve for selecting effect parameters. Pressing both pedals
simultaneously turns the currently selected effect module on or off.
• Bypass (Mute)/Tuner mode:
Pressing a pedal cancels the Bypass (Mute)/Tuner mode.
5
3 4
6
BANK A
PATCH 1
PATCH 2
PATCH 3
PATCH 4
BANK b
PATCH 1
PATCH 2
PATCH 3
PATCH 4
BANK C
PATCH 1
PATCH 2
PATCH 3
PATCH 4
BANK d
PATCH 1
PATCH 2
PATCH 3
PATCH 4
BANK E
PATCH 1
PATCH 2
PATCH 3
PATCH 4
BANK F
PATCH 1
PATCH 2
PATCH 3
PATCH 4
PATCH PATCH NAME COMMENT
SLAP SOLO
BIG FUZZ
TAURUS
OCTAVE CHORUS
VINTAGE
MILLER'S SLAP
LOVERS' FUNK
CHORD CHORUS
BILLY DRIVE
UNITE
CRAZY PHASE
BASS SYNTH
FAT SLAP
WILD
THICK
JET ON
SO FAT
NATURAL CLEAN TONE
ATTRACTIVE SYNTH
U. K. ROCK
T.M. SLAP
GETTIN'
SOLIST
MULTI SYNTH
1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4
BANK
A
b
C
d
E
F
Orthodox slap sound with flanger flavoring
Fuzz tone with straight distortion
Fat synthesizer bass sound
Chorus tone with octave effect
Vintage seventies UK hard rock sound
Fashionable, danceable slap sound
Gritty bass for P-funk bass solos
Ideal sound for six-string bass upper-range chord play
Great for super-fast right hand play
Wah & octave funk bass sound
Percussive slap creates a dazzling effect
Synthesizer bass mixed with direct sound
Straight, fat sound
Combination of resonant wah with drive sound + pedal pitch
Characteristic disco bass sound
For eighth note play with jet sound
Lower-octave addition creates full-bodied sound
Practical, basic bass sound
Distortion + synthesizer sound for on-stage playing
Chorus + pedal sound ideal for picking
Energetic slap sound
Picking nuance changes the distortion intensity
Ideal for ballad solos and backing
Synthesizer bass for any kind of playing style
(LINE OUTPUT
SETTING)
Bekijk gratis de handleiding van Zoom 506, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zoom |
| Model | 506 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2111 MB |
