Zodiac Vortex-Pro VX65 iQ handleiding
Handleiding
Je bekijkt pagina 33 van 36
General Troubleshooting
The following list provides some helpful hints for troubleshooting common
challenges when using the cleaner.
User Issue Possible Cause Suggested Solution
Lights on control unit ash
after pressing Start/Stop
Floating cable not connected Unplug and then reconnect the oating cable to
the control unit.
Cleaner not fully submerged. Remove cleaner from pool and re-submerge.
(see: Install and Submerge the Cleaner).
Poor connection or need to restart
cycle.
Unplug the control unit and reconnect to an
approved power outlet. Press "Start" to begin a
new cycle.
Propeller or wheels may be jammed
and not turning correctly.
Contact your local retailer to request a
diagnostic review. If the problem is not
resolved, contact Zodiac Customer Care at
1300 763 021.
The ashing lights appear
on the control unit during the
cleaning cycle.
Cleaner not fully submerged Remove cleaner from pool and re-submerge.
(see: Install and Submerge the Cleaner).
The cleaner does not stay
on the pool surface or is
oating excessively.
There is air trapped inside the
cleaner housing.
Remove cleaner from pool and re-submerge.
(see: Install and Submerge the Cleaner).
The lter canister is full or dirty. Dispose of debris and thoroughly clean the lter
canister with mild soap and a soft brush. Then,
re-submerge the cleaner (see: Clean the Filter
Canister).
The cleaner is not climbing
walls.
The lter canister is full or dirty. Dispose of debris and thoroughly clean the lter
canister with mild soap and a soft brush. Then,
re-submerge the cleaner (see: Clean the Filter
Canister).
Tyre treads worn down See: Replacing Wear Parts
Conrm appropriate pool chemistry Speak with your pool service professional.
Do not leave cleaner in the pool during any
chemical treatments.
The cleaner is not moving Not connected to electricity. The outlet the control unit is connected to, is
not supplying electrical power. Check that the
outlet to which the control unit is connected is
receiving electricity.
Cycle not started. Press the Start button to initiate a cleaning
cycle.
Reset needed Disconnect the unit power and reconnect after
20 seconds. If the problem is not resolved,
contact your local retailer to request a
diagnostic review or contact Zodiac Customer
Care at 1300 763 021.
Page 33
Zodiac
®
VX65iQ Robotic Pool Cleaner
|
Owner's Manual
Bekijk gratis de handleiding van Zodiac Vortex-Pro VX65 iQ, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zodiac |
| Model | Vortex-Pro VX65 iQ |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4560 MB |
