Zodiac NL LED handleiding

Handleiding

123456789101112/ 12

Afdrukken

Je bekijkt pagina 7 van 12

6

EN

• Each spotlight must be installed at a minimum depth of 10 cm below the

water level.

• The lower cable gland(s) of the juncon box for each spotlight must be

posioned above the pool's maximum water level.

2.1.1 Preparing the pool before installaon

• Install each spotlight in a wall bushing ed with a "sucon port"-type thread of diameter

Ø1.5’’, provided for this purpose during pool construcon (see image ❶).

• The duct or conduit located between the back of the wall bushing and the juncon box

must be waterght because the spotlight is submerged.

• For a opmum pool lighng, each spotlight wall bushing should be posioned 30 to 50 cm

beneath the water level (distance between the top of the lens and the water level).

2.1.2 Installing the appliance

• Slide the power cord through the waterght duct to the juncon box (see image ❷).

• Wind any excess cord away inside the juncon box and conserve sucient length for any

operaons to be performed at a later me.

• Draw the cable and insert the spotlight unl it is ush with the wall bushing (see image ❸).

• If desired, install the white or grey cosmec trim.

• Using the wrench provided, screw the spotlight inside the wall bushing unl ght (see

image ❸). The spotlight's façade must be properly adjusted to the discharge nozzle.

Tip: for easier screwing

• Apply a silicone-based lubricant to the thread.

2.2 I Power supply connecons

• For operaon only with safety isolang transformer properly cered as

being in compliance with the requirements of EN/IEC 61558-2-6 standard.

• Before carrying out work on the appliance, you must rst disconnect the

appliance from the power supply due to the risk of electric shock, which may

cause material damage, serious injury or even death.

• Incorrectly ghtened terminals may cause the terminal unit to heat up and

invalidate the warranty.

• The cord and the juncon box connecon device for the spotlight must not

be completely removed from the duct or pool. There must be enough cord

length in the juncon box to allow the box's spotlight to be removed from

the wall bushing and lied out of the water in order to replace the spotlight's

cartridge.

• Only a qualied and experienced technician is authorised to carry out cabling

work or to replace the power cord.

• The spotlight's power supply must be provided through a 12 VAC transformer (not supplied)

complying with the standards and regulaons in force in the country in which it is installed.

• Electrical protecon: by circuit breaker (D curve) (for rang, see § « 1.2 I Caractérisques

techniques »), with a 30 mA dedicated residual-current protecon system (circuit breaker

or switch) at the head of the line.

• The power supply must correspond to the voltage indicated § « 1.2 I Caractérisques

techniques ».

• The power cord must be protected and insulated from any sharp edges, pressure or hot

elements which may crush, cause abrasion, cuts or other damage to it.

• The electrical wiring must be properly secured from being subjected to unnecessary

movement and strain on connecons.

• To connect the 12 VAC transformer to the juncon box for each spotlight, use the power

cord (RO2V type) adapted for outdoor or buried use (or run the cable into a protecon

duct).

123456789101112/ 12

Bekijk gratis de handleiding van Zodiac NL LED, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Verlichting