Zodiac LM3-40 handleiding
Handleiding
Je bekijkt pagina 7 van 20
7
When the communication link is connected, the pool automation system becomes the master control for
the LM3 enabling the pool owner to control all settings of the LM3 via the controller panel. Warning
messages for check salt and no flow will be displayed at the controller panel. The lights on the LM3 will
illuminate but the buttons will not function.
When the communication link is removed, control of LM3 settings returns to the LM3 control panel.
NOTE: After a change is made at the controller, it may take several seconds for the change to be
reflected on the LM3 fr
ont panel, this delay depends on the controller being used.
Connecting the Communication Cable
1. Remove the LM3 Power Pack cover and connect the 4-conductor communication wire to the “eos
com” terminal block on the LM3 control PCB, mounted in the LM3 cover.The wiring configurations
for the various controllers are as shown below:
Polaris Eos Jandy Aqualink RS Pentair IntelliTouch
Note: The wiring configurations are the same for both Jandy Rev K and
Rev L controllers.
Note: When connecting to the Jandy Aqualink RS controller with Rev L, the LM3
will appear in the settings menu as an "AquaPure" chlor
inator.
2. Fit the communication wire into
the slot beside the cell output
cable cord grip.
3. Secure the wire to the output
cable in two places with cable
ties, cutting any excess off
the ties.
Since the LM3 chlorinator can be
connected to several different
controllers, it is necessary to select
and setup an interface for the specific
unit controlling the LM3.
LM3 Control PCB
Communication Terminal Block
Red
GreenYel/White
Black
Black = Signal+ (A)
Yel/White = Signal- (B)
Green = 0V
Red = V+
Black = Signal+ (A)
Yel/White = Signal- (B)
Green = 0V
Red = V+
LM3 Control PCB
Communication Terminal Block
Red
BlackGreen
Yel/White
Black = 0V
Yel/White = Signal+ (A)
Green = Signal- (B)
Red = V+
LM3 Control PCB
Communication Terminal Block
Red
GreenYel/White
Black
Cable Tie
2 Places
Slot Beside
Cord Grip
Communications
Cable
Bekijk gratis de handleiding van Zodiac LM3-40, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zodiac |
| Model | LM3-40 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1921 MB |
