Zodiac LM3-40 handleiding
Handleiding
Je bekijkt pagina 17 van 20
17
If you experience a problem with your LM3, please follow the troubleshooting steps below to restore
performance. Any type of electrical troubleshooting should be performed by a qualified pool professional
or certified electrician. If further assistance is required, contact Zodiac Customer Service at
800-822-7933. Please have your serial number and date of purchase available when you call.
Troubleshooting
Problem Solution
Water looks clean but there is no chlorine • Confirm that pool water is balanced, total alkalinity is
residual reading.
80 - 120 ppm and pH within 7.2 - 7.6 range
• Inspect cell for calcium build-up, manually clean
if necessary.
• Check for adequate stabilizer (cyanuric acid) levels.
• Increase CHLORINE OUTPUT setting.
• Increase chlorinator run time.
• Verify the pump/filtration system are clean and
operating properly.
• Test for salt concentration and add as needed.
Pool is green, walls are slimy or a Backwash the filter, then manually shock the pool to
chlorine odor is evident. destroy algae, bacteria and other contaminants. After
shock treatment, adjust pH to 7.2 - 7.6 ppm and check
for 1 - 3 ppm chlorine level.
Water causing eye and/or skin irritation. Adjust water to proper pH, 7.2 - 7.6 ppm.
Scale formation on pool equipment. • Adjust water to proper pH, 7.2 - 7.6 ppm.
• Check calcium hardness. Dilute pool with fresh water.
Consult pool professional about sequestering agent.
CHLORINE OUTPUT will not • If yellow light in Chlorine Indicator is flashing, the
reach maximum. chlorinator is reversing polarity to clean electrodes. Wait
approx. 5 min. and output should return to normal.
• If CHECK SALT light is also on, test water for salt
concentration and add salt if necessary. (Water
temperature below 65° may cause light to illuminate.)
• Inspect cell for calcium build-up, manually clean
if necessary.
• Installers only: Verify that chlorinator is connected to
220V and incoming voltage is not low. (Raising salt level
can compensate for low voltage,)
No Flow indicator is illuminated. • Ensure pool pump and filter are clean.
• Make sure valves are open.
Bekijk gratis de handleiding van Zodiac LM3-40, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zodiac |
| Model | LM3-40 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1921 MB |
