Zodiac HPO handleiding
Handleiding
Je bekijkt pagina 10 van 28
9
1.5 I Connecng opons
Connecng the "Heang priority" and "remote control" opons:
• Before any work inside the appliance, you must cut the appliance’s electricity supply as there is
a risk of electric shock which may cause material damage, serious injury or even death.
• There is a risk of electrical return current, injuries, material damage and death when working
on terminals 1 to 2.
• Any connecon error with terminals 1 to 2 may damage the appliance and invalidate its
warranty.
• Terminals 1 to 2 are dedicated to the opons and must never be used to directly supply other
equipment.
• Use cables with a secon of at least 2x0.75 mm² , RO2V type and with a diameter between
8 and 13 mm.
Before connecng any opons: remove the seal (above the cable gland) and install the cable gland provided in order to
pass the cables into the appliance.
The cables used for the opons and the power cord must be kept separate (risk of interference) using a collar inside the
appliance just aer the glands.
1.5.1 "Heang priority" opon
• This funcon allows the appliance to start or maintain ltraon (according to seng "P3") in order to detect the
water temperature and thus acvate the ltraon + heang unit to maintain a constant water temperature. The
lter pump is thus said to be slaved to the heang system.
Filtraon is kept in operaon or acvated if the pool temperature falls below the desired temperature.
• For the connecon, connect the ltraon mer to terminals 1 and 2 (dry contact, no polarity).
1
2
1- 2: Power for the lter pump power contactor coil
: Filtraon mer
: Power contactor (three-pole or two-pole contactor) for the lter pump
motor
: Separate cable for the "heang priority" funcon
: Heat pump terminal block
: Fuse
Informaon: "P3" seng
P3 = 0 "The lter pump starts and stops in line with the heat pump"
P3 = 1 "Filtering is constantly acve"
Water temperature
< temperature setpoint
Water temperature
> temperature setpoint
Timer OFF
P3 = 0 Filtraon ON Filtraon OFF
P3 = 1 Filtraon ON Filtraon ON
• If "Timer" is acve, the lter pump starts and stops in line with the programmed me slots and the
conguraon of the "P3" seng.
Water temperature
< temperature setpoint
Water temperature
> temperature setpoint
Timer ON
P3 = 0
Time slot ON Filtraon ON Filtraon OFF
Time slot OFF Filtraon OFF Filtraon OFF
P3 = 1
Time slot ON Filtraon ON Filtraon ON
Time slot OFF Filtraon OFF Filtraon OFF
1.5.2 "Remote control" opon
This opon enables the appliance's user interface to be transferred in order to control the appliance remotely. To do so,
use the remote control kit.
• Connect the signal wire to the pins on the controller.
• Pass the wire through the connecon block.
• Connect the pins to the electronic board.
Bekijk gratis de handleiding van Zodiac HPO, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zodiac |
| Model | HPO |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6991 MB |
