Zodiac GenSalt OT handleiding
Handleiding
Je bekijkt pagina 39 van 60
37
Con guring the setpoint:
Check that the setpoint has been set to its maximum on the hea ng system.
Con gure the desired water temperature setpoint. The default value is 28°C. This value can be set between 15 and 32°C.
In this case, the temperature sensor of the chlorinator measures the water temperature.
• Press . Browse the menu using the bu ons. Press to con rm.
• Depending on the hea ng system (in par cular when using a heat pump), there may be a delay of a few
minutes between the me the chlorinator closes the AUX2 contact to ac vate the hea ng system and the
e ec ve start-up of the hea ng system (heat pump compressor).
• The chlorinator displays the measured water temperature:
hea ng stopped
hea ng in opera on
The water temperature is measured by the water temperature sensor of the chlorinator:
- If the measured water temperature falls below the setpoint value by 1°C or more (e.g. 28°C -1°C
= 27°C), the relay is closed to ac vate the hea ng system.
- If the measured water temperature is equal to or greater than the setpoint value by 1°C or more
(e.g. 28°C +1°C = 29°C), the relay is opened to deac vate the hea ng system.
EN
Bekijk gratis de handleiding van Zodiac GenSalt OT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zodiac |
| Model | GenSalt OT |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 20621 MB |
