Zodiac GenPH handleiding
Handleiding
Je bekijkt pagina 13 van 20
12
• Rinse the p of the pH sensor with tap water.
• Shake it to remove excess water.
3.3.1 Calibra ng pH 7
• Immerse the sensor in pH 7 bu er solu on.
• Press and hold the
bu on for 5 seconds un l is displayed, then
,
• Press
, the progress bar is displayed:
• A� er about 60 seconds the pH sensor reliability measurement is displayed.
• Depending on the message displayed, perform the corresponding opera ons:
Message
Ac on(s) • turn o the appliance using the master switch
0-1
• replace the bu er solu on and/or the pH
sensor
• restart calibra on
con nue calibra on
• Rinse the p of the pH sensor with tap water.
• Shake it to remove excess water.
3.3.2 Calibra ng pH 4
• Immerse the sensor in pH 4 bu er solu on.
• Press the
bu on to display ,
• Press
, the progress bar is displayed: ,
• A� er about 30 seconds the pH sensor reliability measurement is displayed.
• Depending on the message displayed, perform the corresponding opera ons:
Message
Ac on(s) • turn o the appliance using the master
switch 0-1
• replace the bu er solu on and/or the pH
sensor
• restart calibra on
• press to complete calibra on
• Rinse the p of the pH sensor with tap water.
• Shake it to remove excess water.
• Fit the sensor back onto its holder.
• The sensor measurement is more accurate if the calibra on is performed at 2 points (pH7 and
pH4) rather than at a single point (pH7)
Bekijk gratis de handleiding van Zodiac GenPH, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zodiac |
| Model | GenPH |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5404 MB |
