Zodiac Freerider FR2000 iQ handleiding
Handleiding
Je bekijkt pagina 13 van 24
Page 13
Zodiac
®
Freerider
™
iQ Cordless Robotic Cleaner | Owner’s Manual
4.3 Configure the System
1. On the My Systems page, click + in the upper
right-hand corner to add a system.
2. Choose “Robotic Cleaner” from the list and
choose your model type.
3. Follow on screen prompts to pair your cleaner.
4. Slide the slider right and HOLD for ten
seconds to put the cleaner in Pairing Mode.
Wi-Fi LED Indicates Connection Status
BLINKING - pairing
SOLID - connected to internet
Figure 19. Slide and Hold Right to Pair
5. Follow on-screen prompts to add your cleaner
and connect to your home router.
NOTE: If you have problems connecting, the Wi-Fi
signalmay not be strong enough next to
the pool. Try placing the charging station in
another location closer to your home router
(seeiAquaLinkTroubleshooting section.)
Section 5. iAquaLink
®
Control
Once you have downloaded the iAquaLink app and
connected the device to Wi-Fi, the iAquaLink app
allows for robotic cleaner control from anywhere,
anytime. Functions vary within the iAqualink app
depending on which cleaner model you have.
IMPORTANT
During cleaning cycles while in water, the cleaner will not have
connection to the WiFi. Once the cycle is complete place the cleaner
back on the charging stand to reconnect to the WiFi.
WARNING
Do not enter pool while the robotic cleaner is in water.
5.1 iAquaLink
®
Control Home Screen
App function and design is subject to change.
Start Cleaning
Clean Mode
Battery Charge Status
Green Charged: Fully Charged
Green Charging: Ready For Use
Orange Charging
Orange Partially Charged
5.2 Set Cleaning Mode
Start Cleaning
The factory default cleaning surface setting is
Floor/Wall.
1. From the Home screen, press the Start button
to begin cycle. The cleaner will start when it
detects water and will cancel the cycle if not
submerged after 5 minutes.
NOTE: At the beginning of each cleaning cycle,
the robot confirms your pool parameters
(approximately 10minutes). During this time,
thecleaner does notclimb to the waterline.
2. From the main screen, select Cleaning Mode
toview options.
3. Select Cleaning Mode. The factory default
cleaning mode is Floor/Wall.
Bekijk gratis de handleiding van Zodiac Freerider FR2000 iQ, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zodiac |
| Model | Freerider FR2000 iQ |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4035 MB |
