Zodiac CX35 handleiding
Handleiding
Je bekijkt pagina 4 van 20
Section 2. Getting Started
2.1 GeneralSpecications
The general specications for the cleaner are as follows:
Control box
supply
voltage
220-240 VAC, 50 Hz; short circuit-proof
safety isolating type
Supply voltage 30 V DC
Installed load 150 W max
Cable length 15m (50 ft)
Cleaner size
(WxDxH)
41 x 42 x 25 cm
Weight of Cleaner 9 kg
Filtration
All-purposeltercanister
Cycle lengths Variable programming
The cleaner power supply is double-insulated. A
double-insulated electrical appliance is one which has
been designed in such a way that it does not require a
safety connection to ground. Therefore, devices having
double-insulated construction, such as this cleaner, do
not require a grounded (three-prong) plug.
2.2 Recommendations for Use
• When the pool is dirty, remove the largest
debris using a net in order to optimise cleaner
performance.
• Remove any thermometers, toys, and other objects
that might damage the cleaner.
• The cleaner must operate in pool water with the
following characteristics: chlorine < 3 ppm;
pH 6.8 - 7.6; temperature 15° C - 35° C.
• Fully submerge the cleaner before beginning the
cleaning cycle.
• Start by launching several Floor only mode cleaning
cycles.
• Never cover the control box while the cleaner is in
operation.
• You can operate the filter pump during a cleaning
cycle; any particles in suspension will be filtered
out. However, it is advised to start cleaning with the
filter pump off.
• If part of the pool is not cleaned properly, change
the launch point of the cleaner.
• Launch the cleaner with enough floating cable
to cover the widest distance of the pool to avoid
tangling.
• An average three cycles per week of the cleaner
means your pool will always be clean and the filter
less clogged.
2.3 Unpacking
The packaging should contain the following items:
• Robotic cleaner and floating power cable
• Control unit with power cord
• Transport and storage caddy assembly components
(Figure 1)
(a) handle frame
(b) support blocks (x 2)
(c) wheels (x 2)
(d) wheel locking clips (x 2)
(e) wheel axle / hubcap (x 2)
(f) base unit
(g) caddy handle
A
x 2
B
C
D
x 2
x 2
E
x 2
F
G
Figure 1. Transport Caddy Assembly
Components
When unpacking the cleaner and its components:
• Check to make sure each component is in the box.
• Check cleaner and components for damage during
transport.
• If there are missing parts or damage, contact
Zodiac Technical Support: 1300 763 021
4
H0574000_REVA
Bekijk gratis de handleiding van Zodiac CX35, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zodiac |
| Model | CX35 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3788 MB |
