Handleiding
Je bekijkt pagina 23 van 46
19
Flame Adjustment
OPERATION
MANUAL FLAME ADJUSTMENT
• Each range includes a flame adjustment feature if burners
experience irregular flame sizes or are too yellow or
orange in color. Ranges are designed to ensure flames
are set at appropriate levels. Should an adjustment be
needed, follow these steps:
• Light one burner at a time and set it to the lowest position.
Next, remove the knob by firmly and carefully pulling it
straight out.
• Inside each burner is an adjustment valve. Using a 2 mm x
50 mm flathead screwdriver, locate the adjustment screw
(see diagram — the screw is on the right) and turn the
screwdriver to the right or left until the flame is adjusted to
the desired minimum. Use a flashlight if it’s difficult to see
the adjustment screw.
• Make sure the flame does not go out when switching
quickly from the HI to the LO position. NOTE: The high
flame setting cannot be adjusted to be lower.
• NOTE: For the dual burner knobs on all three models,
there are 2 screws to adjust if needed —1 for the inner
ring and 1 for the outer ring. These screws are located on
the left side of the adjustment valve.
0.0.0.
2.0 x 50 mm
2.0 x 50 mm
Scan to follow along with a video.
Bekijk gratis de handleiding van ZLine CGR48, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ZLine |
| Model | CGR48 |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 6880 MB |
