Zipper ZI-STE1000INV handleiding
Handleiding
Je bekijkt pagina 28 van 41
OPERATION
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at 28
ZI-STE1000INV
13.5 Operating instructions
NOTE
• Always place the machine on a firm and flat surface! No turning, tilting or moving
during the engine is running.
• Always check oil and fuel level before starting.
• Do not connect the device before the machine is running at full speed.
• Disconnect the device before turning the machine off.
• Connected devices must be in perfect condition.
• Keep the cable length to the device as short as possible.
NOTE: For a period of 5 minutes, the machine is designed to provide maximum performance. For
continuous operation, the specified rated performance should not be exceeded.
13.5.1 Operation of the machine to over 1500m above sea level
• When operating at high altitudes, the air/fuel mixture becomes too dense due to the lower
oxygen content in the air. This leads to loss of power, increased fuel consumption, rapid wear
of the spark plugs and difficult starting of the engine.
13.5.2 Connecting devices
• Before connecting a device to the machine you must check its perfect condition.
• When you recognize that a connected device acts unusual you must stop the machine and
disconnect the device. Control whether the device is damaged or if the machine was over-
loaded by the device.
• The max. performance of the connected devices must be within the specifications for the
machine.
NOTE: Most devices (motor) require more starting current to start than specified. A short exceed of
the normed power capacity of the machine is possible but if this happens oftener the life time of the
machine will be shortened.
Please consult the performance specifications on the connected electrical devices, these can usually
be found next to the serial or manufacturing number.
Please consider: Some devices, for instance cooling devices need up to 5 times more starting current
than current during the operation.
NOTE: If the machine is continuously overloaded or if a short circuit occurs, the power supply to the
connected devices is interrupted. In this case, the overload alarm lights up continuously. If this occurs,
switch off the machine and check the problem.
13.6 Operation
13.6.1 Switch the engine/machine on
NOTE: If a device is connected to the machine, disconnect it.
• Turn the fuel filler cap lever to the "ON" position.
NOTE: When starting the machine for the first time or after a
longer period of storage, set the lever on the fuel filler cap to
the "ON" position 10-20 seconds before start-up.
• Turn the ON-OFF-switch (2) to the "ON" position.
Bekijk gratis de handleiding van Zipper ZI-STE1000INV, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zipper |
| Model | ZI-STE1000INV |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9420 MB |
Caratteristiche Prodotto
| Kleur van het product | Black, Green |
| Gewicht | 9900 g |
| Gewicht verpakking | 11500 g |
| Breedte verpakking | 220 mm |
| Diepte verpakking | 415 mm |
