Zelmer W&D Leon ZVC9130M handleiding
Handleiding
Je bekijkt pagina 15 van 84
15
PL
EN
Before wet cleaning the carpet, check the colour fasteness of cleaned carpet. Put a
small amount of prepared solution on white cloth and clean manually the carpet at
least visible place. If the cloth is dyed, it means that the carpet colour are not perma-
nent and the carpet cannot be cleaned using cleaning uid.
During wet vacuuming, the vacuum cleaner is designed to suck up liquids. Limit the
suction of dust and other solid fractions.
5. Insert the cleaning liquid container back to the previous position and press the container to x it correctly.
6. Insert the container together with the water lter module (lter unit and partition) to the vacuum cleaner.
For protection against the formation of foam or at its formation, when cleaning ll the rear tank with an an-
ti-foaming agent recommended by the company ZELMER, in the amounts specied on the label:
7. Press the pump switch.
Use only the large or small atomizing nozzle for wet vacuum cleaning.
If the nozzle does not atomize water although the pump is switched on, check if the following items are
correctly installed: the cleaning liquid container, the fastening of the stub pipe in the valve in the base of
the vacuum cleaner or fastening of the hose end in the atomizing nozzle, check if the atomizing nozzle is
not clogged.
8. Press the button adjusting the inow of water to the nozzle on the hose handle.
If you press the button in a pulsating manner, the water shall temporarily ow in a slower manner to the
nozzle, if you press and slide the button backwards, the water shall be continuously supplied to the nozzle.
The handle is also equipped with a slider to adjust the suction power. Do not uncover this opening while
picking up water or using the wet cleaning function.
Do not spray the cleaning liquid in one place on the carpet for too long in order not to
soak the carpet.
• You should to clean the carpet in such a way that during and immediately after cleaning nobody walks on
the cleaned surface. After cleaning one part of the carpet stop the spraying process and dry the carpet by
sliding the nozzle back and forth. Repeat until the whole surface of the carpet is dried.
• After ending the spraying process switch off the pump and press the button adjusting the water inow to
the nozzle for a moment to “release the pressure”.
The vacuum cleaner is equipped with a oat which will automatically block the suction
if the foam lter is heavily dirty or the liquid exceeds the maximum level. it is manifest-
ed by a pulsing limitation of the motor power and the lighting up of the clogged air inlet
indicator. In such a case switch off the vacuum cleaner by pressing the on/off button,
unplug the appliance, clean the lter and empty the container.
Make sure the carpet is not soaked. It may lead to a permanent deformation of the car-
pet.
Bekijk gratis de handleiding van Zelmer W&D Leon ZVC9130M, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zelmer |
| Model | W&D Leon ZVC9130M |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 7237 MB |
