Zelmer W&D AquaLeon Pro ZVC9140D handleiding

Stofzuiger

Zelmer

84 pagina's

PDF beschikbaar

Handleiding

PICKING UP WATER

If you want to use the vacuum cleaner to vacuum liquid in the container, the vacuum cleaner should be

prepared as in the case of vacuum cleaning with the use of the water lter module except that:

1. The container should be empty.

2. You are to use atomizing nozzles (large or small), large atomizing nozzle with the gathering attachment

or the nozzle for pick up water.

Do not operate the vacuum cleaner with a full container! Do not vacuum large amounts

of liquid at a time. Empty the water tank on a regular basis.

If the water exceeds the maximum level during vacuuming, the oat will automatically block the suction. The

maximum capacity of the container is about 5 l. in such a case proceed in the manner described above in

the part concerning the blocking of suction caused by a dirty foam lter (pulsating motor speed).

END OF OPERATION CLEANING AND MAINTENANCE

• Switch off the vacuum by pressing the on/off button and unplug the appliance.

• Wind cord by pressing the cord rewind button.

While doing this hold the cord to make sure it is not tangled and the plug does not hit the vacuum cleaner

housing.

• Turn the end of the hose until the tops of the mark on the end of the hose and on the vacuum cleaner

housing are in the same position and pull the hose out of the opening.

• Remove the stub pipe of the hose by pressing the red button on the valve and pull the stub pipe.

• Disconnect the telescopic tube from the hose and the nozzle or brush.

• Pour the dirty water out of the container.

• It is recommended to wash the container, lters and partition thoroughly after each use- changing water

several times.

• After using the wet cleaning function thoroughly wash all attachments used in this process (hose, tubes,

accessories).

If you do not clean the above-mentioned parts or clean them

Insufciently it may lead to the loss of the ltration capabilities of the inserts and foam

and cause the formation of bacteria and mites.

Dry all the cleaned parts thoroughly before reassembly.

FILTER DISASSEMBLY

FOAM FILTER Ӏ

It is recommended to wear rubber protective gloves while dismantling the lter

1. Grab the foam lter with your ngers and remove it from the lter unit body.

2. Wash under running water, dry and reinsert.

FOAM FILTER Ӏ Ӏ

1. Open the lid of the lter unit by pulling the

handle upwards.

2. Take out the lter, wash it under running water, dry and reinsert.

Bekijk gratis de handleiding van Zelmer W&D AquaLeon Pro ZVC9140D, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.